论文部分内容阅读
1.按照工艺文件和调整卡所制定的规格和编号领取刀盘和工具。 2.按照调整卡上制定的各项参数,进行机床的刀位、轮位、床位、分齿和滚比等调整及搭配挂轮。按刀盘直径、工件材料等合理选用切削速度(生产高速钢刀头一般选择30m/min)和进给挂轮。 3.搭配交换挂轮时,必须切断机床电源,挂轮上的齿数钢印必须向外,以便查对,齿侧间隙保证在0.05～0.08mm。各紧定螺钉螺帽,在调整完毕后必须检查是否已收紧。最后,核对各挂轮的主被动位置和齿数的正确性后
1. Pick cutters and tools according to the specifications and numbers set by the process and adjustment cards. 2. According to the adjustment card to develop the various parameters, the machine tool position, wheel position, bed, tooth and roll ratio adjustment and with the hanging wheel. According to the cutter diameter, the workpiece material and other reasonable selection of cutting speed (production HSS general choice 30m / min) and the feed wheel. 3. With the exchange of the wheel, you must cut off the power of the machine, the number of teeth on the wheel on the seal must be outward, in order to check, the side clearance to ensure 0.05 ~ 0.08mm. Each set screw nut, must be checked after adjustment is tightened. Finally, check the main passive position and the number of teeth after the correct number of teeth