【摘 要】
：
High strength Al-Zn-Mg-Cu alloys were prepared by spray deposition and casting techniques.The microstructures of the Al-Zn-Mg-Cu alloys were studied using scann
【机 构】
：
State Key Lab for Fabrication & Processing of Nonferrous Metals/National Analysis and Testing Center
论文部分内容阅读
High strength Al-Zn-Mg-Cu alloys were prepared by spray deposition and casting techniques.The microstructures of the Al-Zn-Mg-Cu alloys were studied using scanning electron microscopy,transmission electron microscopy,and X-ray diffraction.Secondary phases in the microstructures of the alloys prepared by spray deposition and conventional cast were examined.The results indicate that under the conventional casting condition,the microstructure of the alloy revealed the presence of coarse Al/Mg(ZnCu)2 eutectic phases,and the spray deposited process causes an obvious modification in size,morphology,and distribution of secondary phases in the microstructure as well as reduction of segregation.The superior microstructure of the spray-deposited Al-Zn-Mg-Cu alloy was attributed to the high cooling rate,and associated with the rapid solidification process.
其他文献
Finite element model was developed to analyze thermal residual stress distribution of diamond coating on graded and homogeneous substrates. Graded cemented carb
The RNG к-ε model considering the buoyancy effect,which is solved by the hybrid finite analytic method,is used to simulate the mixture of the horizontal round
The extraction technology of vanadium from stone coal by means of no-salt-roasting and dilute acid solution leaching treatment has the advantages of low polluti
To investigate the formation of internal cracks in steel billets during soft reduction, fully coupled thermo-mechanical finite element models were developed usi
Based on unit cell model,the 3D 4-directional braided composites can be simplified as unidirectional composites with different local axial coordinate system and
To obtain homogenous layered oxide Li(Co1/3Ni1/3Ni1/3Mn1/3)O2 as a lithium insertion positive electrode material,the sol-gel process using citric acid as a chel
The roll contour pattern and variety of work and backup roils in service and its effect on profile and flatness control performance in 1 700 mm hot strip mill a
After being treated in different ways,Zr-Sn-Nb-Fe alloy specimens are exposed in 0.01mol/L LiOH aqueous solution at 350℃ under 16.8 MPa.The examination of micr
Two finite element(FE) models were built up for analysis of stress field in the lining of aluminum electrolysis cells. Distribution of sodium concentration in c
Surface modification of up-conversion luminescence materials (Na[Y0.57Yb0.39Er0.04]F4 modified by amino groups) by grafting and modifying with aldehyde groups w