论文部分内容阅读
一、采剪接穗 在枝梢抽生前,于晴天上午采穗,然后剪除叶片,用湿麻布包好,放阴凉处备用。 二、切割芽接口 在砧木离地10～15厘米处开芽接口,接口大小根据砧粗而定,一般宽0.8～1厘米,长3.5厘米。切割时从砧木树皮上用芽接刀由上至下划两道切口,切口上部连成舌形,深达木质部,再从舌形尖端将皮层向下撕开,撕时木质部上不能残留韧皮组织。然后将撕开皮层大部份切除,留下一小段做胶囊皮。注意保持切口干净。
First, shearing scion Sucking shoots in the shoots, ear harvest in the sunny morning, and then cut the leaves, wrapped with a wet sack, put the shade ready. Second, the cut bud interface in the rootstock from 10 to 15 centimeters open bud interface, the interface size according to the anvil rough, generally 0.8 to 1 cm wide and 3.5 cm long. Cut from the bark on the rootstock with buds from the top to the bottom of the cut two incisions, the upper part of the incision connected into the tongue, deep xylem, and then from the tongue tip of the cortex tear down, tearing the xylem can not remain phloem organization. Then most of the excision of the cortex resection, leaving a small rubber capsule to make skin. Take care to keep the incision clean.