论文部分内容阅读
我厂因没有加工锥柄插齿刀的设备,所以在Y54型插齿机上改革了夹具,加工出了锥柄插齿刀。夹具安装在Y54型插齿机让刀机构工作台上,先用内六角螺钉将底座8固定在让刀机构工作台上(附图)。接着将锥度定心轴9和主动伞齿轮7固定在插齿机分度蜗轮轴10孔中,使三者变成一体。然后将倾斜板6连同被动伞齿轮2、卡头体4放在底座8上,用内六角螺钉紧固倾斜板6,打开油孔压盖注好油,按上压盖5拧紧螺钉。
I plant because there is no taper shank gear shaper processing equipment, so in the Y54 shaper gear on the reform of the fixture, taper Shank shaper cutter. Fixture installed in the Y54-type gear shaper cutter body table, the first hex socket head screws to the base 8 fixed to the knife body table (with photos). Next, the taper centering shaft 9 and the driving bevel gear 7 are fixed in the hole of the gear shaper worm shaft 10 so that the three are integrated. Then the inclined plate 6 together with the passive bevel gear 2, the chuck body 4 on the base 8, with a hexagonal screw tighten the inclined plate 6, open the hole gland Note oil, press the gland 5 to tighten the screw.