论文部分内容阅读
4射频各级工作状态的调整4 1射频推动级的调整4.1.1调整前的准备工作(1)检查接线是否有误 ,波段接点是否正确。(2 )按相应值预置好自动调谐控制电路的相应电阻。(3)将调整监控时消除故障指示所外接的电阻恢复。(4 )接通 3k V、90 0 V输出线 ,合通 3k V、90 0 V自动断路器。在按
4 RF work status adjustment at all levels 4 1 RF drive level adjustment 4.1.1 Preparation before adjustment (1) Check the wiring is correct, the band contacts are correct. (2) Preset the corresponding resistance of the automatic tuning control circuit according to the corresponding value. (3) will adjust the monitoring eliminate the fault indication of the external resistance recovery. (4) Turn on the 3k V, 90 0 V output line and turn on the 3k V, 90 0 V automatic circuit breaker. Press