【摘 要】
：
This paper proposes a method for determining the gas recovery of water-drive gas reservoirs. First, the water influx coefficientB in the theoretical formula=(1)
论文部分内容阅读
This paper proposes a method for determining the gas recovery of water-drive gas reservoirs. First, the water influx coefficientB in the theoretical formula=(1)/(1B)rggpRR?? is used to determine the influence of the aquifer behavior. According to the theoretical formula, the relationship between the normalized pressurerp and the degree of the reserve recovery gR can be obtained with different values ofB, which can be used to determine the activity level of the aquifer behavior. Second, according to=(1)/(1)ragavapRaE?? (where=1gr/gia?SS), the relationship between the normalized abandonment pressure rap and the ultimate gas recoverygaR can be obtained, as the Agarwal end-point line. The intersection of the above two lines represents the value of the estimated ultimate gas recovery and the normalized abandonment pressurerap. Finally, an evaluation table and a set of demarcation charts are established, with different values ofSgr/Sgi andvaE as well as the water influx coefficientB, which can be used to determine the gas recovery of water-drive gas reservoirs with different activity levels of the aquifer behavior.
其他文献
今以左旋齿轮为例:将分度头安装在铣床工作台上,插律检查符合要求后装上斜齿轮。选择一个比较好的齿作为测量对象。将百分表座装在床身上,不随工作台移动,表头压在齿的一端A
Propulsive performance of a passively flapping plate in a uniform viscous flow has been studied numerically by means of a multiblock lattice Boltzmann method. T
热电偶在工业领域内应用非常广泛,凡要对机件温度进行监测的地方,大多是利用热电偶采样。我矿抽风机轴承温度的测量就是利用热电偶进行采样的。近几年因地方小井的乱采乱挖,
我厂使用的Z28-20滚丝机,其联轴器结构如图1所示。在滚压直径大于M30、材料为40Cr的螺栓时,联轴器结合子出现
I used Z28-20 rolling machine, the coupling structure sho
Based on theε-support vector regression, three modelling methods for the ship manoeuvring motion, i.e., the white-box modelling, the grey-box modelling and the
Interblade vortices can greatly influence the stable operations of Francis turbines. As visible interblade vortices are essentially cavitating flows, i.e., the
Background:Nonfluoroscopic three-dimensional electroanatomical system is widely used nowadays,but X-ray remains indispensable for complex electrophysiology proc
4.半年检查与维护 除包括月检查内容外还应有: (1)检查所有的减速器的齿轮啮合和磨损情况,齿面点蚀损坏不应超过啮合面的30％,且深度不超过原齿厚的10％(固定弦齿厚);齿轮的齿厚
Energy dissipations induced by the hydraulic jump and the trajectory jet are the most widely known as the two dissipation modes at the downstream of flood disch