用一台CMC-80微型机同时控制2台MY210型床单被单网板印花机

• 作 者: 蒋建秋
• 机 构: 湖南株洲床单厂,
• 出 处: 微型机与应用
• 发表日期: 1986年01期
• 关键词: 床单 花机 台板 网板 硬件接口电路 印花台板 CMC-80 MY210 上下运动 微型机

MY210型网板印花机的工作过程简要的来说是让25块活动的印花台板分上下两层,沿水平方向周期循环运动。将被印花的床单平摊在台板上,印花网板在上层台板之上作上下运动,台板每推进一次,印花网板下降,括板印花,然后网板上升,台板再次推进,周期循环下去。工艺流程图见图1。本文仅对硬件接口电路及部分软件进行讨论。

MY210 type screen printing machine working process is briefly let 25 activities of the printing platen points up and down the two layers, along the horizontal cycle cyclical movement. Will be printed sheets flat on the platen, printing stencil in the upper platen up and down movement, platen every push, printing stencil down, including the printing plate, and then stencil up, the platen to promote again, The cycle goes on. Process flow shown in Figure 1. This article only discusses the hardware interface circuit and some software.