简易电极丝垂直找正器

• 作 者: 刘玉锁
• 出 处: 电加工
• 发表日期: 1990年03期
• 关键词: 电极丝 找正 加工精度要求 检具 数控线切割 极简单 钼丝 座底 发光二极管 铂丝

我们为电火花数控线切割制做了一个极简单,实用而又能满足加工精度要求的钼丝垂直找正器。由检具和电路两部分组成。检具(图1)由尺座、触头、绝缘体组成。在制做中要保证上组 AB 触头与下组 CD 触头和尺座底面垂直,垂直度应小于0.002/100mm,并在制做中保证触头和触头之间,触头与尺座之间相互绝缘、牢固。电路:如图2所示上组电路由两节五号

We have made a very simple, practical and can meet the machining accuracy requirements of molybdenum wire vertical alignment device for EDM CNC wire cutting. From the fixture and circuit of two parts. Gages (Figure 1) from the base, contacts, insulators. Make in the system to make sure that the AB contact with the next set of CD contacts and feet perpendicular to the bottom of the base, the verticality should be less than 0.002 / 100mm, and in the production process to ensure contacts and contacts, contacts and feet Block Insulation between each other, solid. Circuit: As shown in Figure 2, the circuit consists of two sections on the 5th