砂砾岩储层有效厚度研究

来源 :大庆石油地质与开发 | 被引量 : 0次 | 上传用户:ztt399
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
用容积法计算油气储量时,影响储量计算精度的因素之一是储层有效厚度。砂砾岩由于其岩性复杂、非均质性强,岩石骨架对电测曲线的影响较大,加上常规实验室物性分析精度不高,使砂砾岩储层有效厚度划分比较困难。本文根据大庆油田侏罗系、白垩系砂砾岩储层的特征,利用实际资料确定出储层有效厚度下限标准,并结合实例提出利用全直径物性分析资料、气测资料及电测曲线综合确定有效厚度的方法和步骤。 When volumetric method is used to calculate oil and gas reserves, one of the factors affecting the calculation accuracy of reserves is the effective reservoir thickness. Because of its complex lithology and heterogeneity, the influence of rock skeleton on the electrical measurement curve is larger, and the accuracy of physical property analysis in conventional laboratories is not high, making it difficult to classify the effective thickness of glutenite reservoir. Based on the characteristics of the Jurassic and Cretaceous conglomerate reservoirs in Daqing Oilfield, the authors used the actual data to determine the lower limit of effective thickness of reservoirs. Combined with the examples, the authors proposed the use of full-diameter physical analysis data, gas measurement data and electrical measurement curves to determine the effective Methods and steps of thickness.
其他文献
在 KF- A12 0 3负载型固体碱催化下 ,绕丹宁和芳香醛发生缩合反应 ,高产率地合成了 5-芳基亚甲基绕丹宁 ,测定了产物在种溶剂中的紫外光谱 ,其最大吸收频率νmaxuv与 Hammett
本文以DD-680大客车为例。根据使用及路试中暴露的问题,运用系统分析原理,导出了大客车车内座椅响应随位置呈抛物线形分布的规律。评述了M_0Mitschke对分 This article take
本文报道用CO2与环氧丙烷共聚产物聚碳酸亚丙酯和环氧丙烷均聚物来制备聚氨酯(PPCPOPU)弹性体。探讨了这类弹性体的最佳合成方法,考察了异氰酸酯基与羟基的比值;扩链交联剂用量等
一、轴瓦的张力(扩张量) 轴瓦的张力(扩张量)如图1所示,是指轴瓦的开口尺寸A(自然状态)大于连杆盖(或连杆)相应尺寸B。装配时,使轴瓦产生弹性弯曲嵌入连杆盖(连杆)时,连杆盖
在酸催化下 ,从化合物 2 -[1 ,2 / 3-亚乙 /丙二硫基 ] -3-羰基 -5-芳基 -4 -戊烯酸 2出发 ,经加热分解 ,合成了标题化合物 1 -[1 ,2 / 3-亚乙 /丙二硫基 ] -3-羰基 -5-芳基
临床资料:1994~1998年我院收治小儿中毒性痢疾50例,年龄最小2岁,最大14岁。诊断符合文献标准(褚福棠主编.实用儿科学.第4版.第843页)。患儿入院后均给予对症治疗,包括扩容、纠正酸中毒、抗休克以及液体疗
Dielectric monitoring of the adsorption or release process of salicylic acid (SA) by chitosan membrane shows that the dielectric spectra of the chitosan membran
斜航测流成果的好坏,经我们试验发现与以下两点有很密切的关系:(1)测船行速的均匀问题;(2)对轴角的掌握问题。为了解决这些问题,一九五三年经我站同志们研究,在双舟测船上安
一、监工员如何检查堤坡标准设堤坡设计标准为一比三,可用公尺杆由堤口向里量三尺,将公尺杆直竖于该处,用眼由公尺杆顶,经堤口直视堤脚,如三点均与视线相平,则坡度合乎标准