Coating of magnesium powder by rapid expansion of supercritical solution method

来源 :中国有色金属学会会刊(英文版) | 被引量 : 0次 | 上传用户:lclanki
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
In order to solve the reserve stability problem of pyrotechnic explosives containing magnesium powder,a coating method named rapid expansion of supercritical fluid is studied. Continuous coating film of paraffin can be formed on the surface of magnesium powder when paraffin content is about 1.5%. Humidity resistance property of the coated magnesium is promoted obviously. The flame sensitivity of the coated magnesium is 4.8% lower than that of the original magnesium powder after mixed with oxidant. The burning velocity of the coated magnesium is 4.7% lower than that of the contrastive sample. This method may be used to enhance the reserve stability problem of pyrotechnic explosives and the safety of magnesium powder modifying process.
其他文献
The phase separation in Ni75AlxV25-x alloys incorporated with the elastic stress was investigated using the microscopic phase-field model. The final morphology
In order to examine the dependences of tensile properties of a forged Mg-13Li-X alloy on hot-rolling deformation and the underlying mechanisms tensile tests, re
China is quite poor in argent resource. Roughly 80% of this industrial argent is imported every year. In order to improve the situation, we took advantage of ra
High-resolution X-ray diffractometry (HRXRD) was used to assess the quality of 6H-SiC crystals grown by sublimation method. The results show the occurrence of l
Effects of the process parameters, including deformation temperature, punch velocity and extrusion ratio, on the deformation and microstructure characterization
The nanocrystalline Fe82Nb7B10Cu1 soft magnetic ribbons were treated with the mixture gas flow of ammonia and hydrogen at 673 K. The influence of the nitridatio
This paper reports the influence of heat transfer surface treatment on the formation of calcium sulphate deposit during flow boiling heat transfer. The surface
The alternative heating/cooling cycles(thermal fatigue)of K465 superalloy were carried out. The specimens were held at 1 050 ℃ for 300 s, then quenched into 20
The hot rheological forming method was proposed to form the second titanium alloy vane disk. The hot rheological forming process of the TC11 titanium vane disk
LiFePO4 thin films were prepared by sol-gel technique. The phase and surface morphology were characterized by X-ray diffraction and scanning electron microscopy