论文部分内容阅读
一、引言在雷达和雷达导引系统的设计中,都要考虑目标噪音所引起的误差问题,目前,我们所看到的这方面文献很多,但都是针对某种特殊情况下而讨论的,对于我们所遇到的特定情况不太实用,为此,我们编写本文,企图针对我们所遇到的特定情况,把目标噪音的计算系统化。本文虽然主要针对圆锥扫描系统讨论的,但其结果略加修正也可以推广到单脉冲系统。在计算目标噪音时,首先遇到的问题就是目标噪音的原始数据问题,我们准备在另外的文章中专门发表我们所收集到的一些数据,因此,本文不给出具体数据。
I. INTRODUCTION In the design of radar and radar guidance systems, all the errors caused by the target noise should be considered. At present, there are many references in this area which we have seen, but all are discussed under some special circumstances. For the specific case we encountered is not practical, and for this reason, we prepared this article in an attempt to systematize the calculation of the target noise for the specific situation we encountered. Although this paper mainly focuses on the conical scanning system, its results can be generalized to single pulse systems with slight modifications. When calculating the target noise, the first problem encountered is the original data problem of the target noise. We are going to publish some of the data we collected in a separate article. Therefore, this article does not give any specific data.