论文部分内容阅读
The compressive behaviors of medium carbon steel specimens were investigated over a wide range of temperatures and strain rates using a Gleeble-3500 thermo-simulation machine.The results show that the flow stress increased with strain at first,and then gradually decreased after reaching apeak value.The flow stress softening rate at a high strain rate was larger than that at a low strain rate.The effects of deformation heating and friction on flow stress were analyzed.A new friction correction method,wherein the effect of strain on frictional coefficient was considered,was established here.The stresses revised by the new method deviated from the measured stresses with increasing strain.Meanwhile,the apparent frictional coefficient variation law with strain was obtained.The frictional coefficient increased as the strain increased and then slightly decreased after maintaining a constant value.The stress was corrected by considering deformation heating.The accuracy of the temperature correction method was verified using a special experiment.The results of the verification experiment show that the temperature correction method exhibited a good accuracy in calculating the variation of stress caused by deformation heating.A constitutive model considering strain was proposed here to describe the deformation behaviors.Compared with experimental data,the modified constitutive model exhibited a good accuracy as to constitutive correlation.
The compressive behaviors of medium carbon steel specimens were investigated over a wide range of temperatures and strain rates using a Gleeble-3500 thermo-simulation machine. The results show that the flow stress increased with strain at first, and then The flow stress softening rate at a high strain rate was larger than that at a low strain rate was , was established here. the stresses revised by the new method deviated from the measured stresses with increasing strain.Meanwhile, the apparent frictional coefficient variation law with strain was and. the frictional coefficient increased as the strain increased and then slightly decreased after maintaining a constant value. the stress was corrected by considering deformation deformation. the accuracy of the temperature corre ction method was verified using a special experiment. The results of the verification experiment show that the temperature correction method exhibited a good accuracy in calculating the variation of stress caused by deformation heating. A constitutive model considering strain was proposed here to describe the deformation behaviors. Compared with experimental data, the modified constitutive model exhibits a good accuracy as to constitutive correlation.