弹性橡胶垫层在一吨模锻锤上的应用

• 作 者: 王关土
• 出 处: 洪都科技
• 发表日期: 1980年01期
• 关键词: 模锻锤 垫层 弹性 橡胶 机床工作 橡胶垫 硬木 机座 锻锤 砧座

在锻锤、落锤等设备的砧座(或机座)下面都垫有弹性垫层。这种垫层历来都使用硬度高、材质均匀、弹性好、耐腐蚀的优质硬木,如橡木、榨木等。但是,由于这类木料来源困难、工艺复杂、使用寿命短,所以,我厂在一九七九年大修M211型一吨模锻锤时,参考有关资料,试用橡胶垫代替原来的木质垫。经过半年多的使用,证明机床工作稳定,情况良好。现简介如下。

In forging hammer, drop hammer and other equipment anvil (or base) are cushion under the cushion. This cushion has always been the use of high hardness, uniform material, good elasticity, corrosion-resistant high-quality hardwood, such as oak, pressed wood and so on. However, due to the difficult source of such lumber, the complicated technology and the short service life, when we overhauled the M211 one-ton die forging hammer in 1979, we tried to replace the original wooden mats by referring to the relevant information. After more than six months of use, the machine proved to be stable and in good condition. Now the introduction is as follows.