Hospitals’ responsibility in response to the threat of infectious disease outbreak in the context of

来源 :全球健康杂志(英文) | 被引量 : 0次 | 上传用户:kelu1fu
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
The WHO declared the coronavirus disease 2019 (COVID-19) outbreak as a public health emergency of international concern on January 30, 2020, and then a pandemic on March 11, 2020. COVID-19 affected over 200 countries and territories worldwide, with 25,541,380 confirmed cases and 852,000 deaths associated with COVID-19 globally, as of September 1, 2020. 1While facing such a public health emergency, hospitals were on the front line to deliver health care and psychological services. The early detection, diagnosis, reporting, isolation, and clinical management of patients during a public health emergency required the extensive involvement of hospitals in all aspects. The response capacity of hospitals directly determined the outcomes of the prevention and control of an outbreak. The COVID-19 pandemic has affected almost all nations and territories regardless of their development level or geographic location, although suitable risk mitigation measures differ between developing and developed countries. In low- and middle-income countries (LMICs), the consequences of the pandemic could be more complicated because incidence and mortality might be associated more with a fragile health care system and shortage of related resources. 2-3 As evidenced by the situation in Bangladesh, India, Kenya, South Africa, and other LMICs, socioeconomic status (SES) disparity was a major factor in the spread of disease, potentially leading to alarmingly insufficient preparedness and responses in dealing with the COVID-19 pandemic. 4 Conversely, the pandemic might also bring more unpredictable socioeconomic and long-term impacts in LMICs, and those with lower SES fare worse in these situations. This review aimed to summarize the responsibilities of and measures taken by hospitals in combatting the COVID-19 outbreak. Our findings are hoped to provide experiences, as well as lessons and potential implications for LMICs.
其他文献
钛具有比强度高、耐腐蚀、无磁、超导、形状记忆、生物相容性好等优点,特别适合作为结构材料和特种材料使用,但与不锈钢、铜、镍等材料相比,钛材的价格明显偏高,这极大地影响
本文研究了不同轧制温度对医用Ti6A14V热轧板材显微组织和性能的影响,分别选取了三个轧制温度:940℃、850℃、800℃,并分别在三个制度下的板材上取样,然后用相同的热处理温度
名优蚕豆品种──透心绿保山地区农科所678000鲁宣华透心绿蚕豆是保山市坝区农民种植历史较悠久的一个名优地方品种。该品种的突出特点是种支白、心透绿、品质佳。用鲜豆做出的菜肴
采用ICP-AES法直接测定钛合金中Ta、Nb、W元素。通过分析条件的优化遴选,确定了仪器的最佳工作参数和分析线。采用基体匹配及内标法进行校正,并进行了方法精密度,准确度试验,
研究轧制温度分别采用970℃和900℃轧制Ti-6A1-7Nb的板材组织和性能上的差异.970℃热轧和900℃热轧原始显微组织均为两相区加工组织——初生α相加上β转变基体.与970℃热轧
本文介绍了宝鸡钛业股份有限公司生产的φ265Ti-6242S钛合金棒材的生产工艺和棒材的组织、性能及探伤水平.采用多通道分区水浸法探伤,发现棒材底波均匀性好,声能衰减均匀,噪
本文主要研究了冷轧钛带卷真空热处理工艺过程及钛带卷热处理时产生粘结现象的原因,着重分析了带卷真空退火时升温方式、卷曲张力、退火时间和温度、带材表面粗糙度对粘结的
本文研究了Ti3Al基合金热轧板材(1.9×900×3000mm)的热处理工艺对组织和性能的影响,研究表明:当板材在900℃~1050℃退火时,退火温度对微观组织和室温塑性(δ5)影响较为明显,
曾为清代诗坛宗仰达五十年之久的袁枚,固然以其诗作及诗论著称于世,然尤其难能可贵的,还在于他是个善于教人作诗的有心人。请看袁枚在《随园诗话》中的一段话: 霞裳(袁枚门
新番4号是利用引-6和美东两个加工番茄亲本配制出的一代杂种,生长势强,品质好,含可溶性固形物5.65%,番茄红素12.63mg/100g,平均单果重71.38g,果肉厚0.98cm,耐贮运,可进行无支架栽培,每667m2产量5000~7000kg。至1995年,在新疆已推广333hm2以上。 Xi