修理小量块的工具

• 作 者: 王汉民
• 出 处: 计量工作
• 发表日期: 1977年05期
• 关键词: 研合 易弯曲 光洁度 和容 多些 修理方法 尺寸 平行性 平面 平面性

在量块修理时,对尺寸在5.5毫米以下的小量块,普遍运用的修理方法是研合在平晶或废量块上。这种方法迄今为止还是行之有效的。但对严重丧失研合性和容易弯曲变形的薄量块,在修理时就较困难;化费的时间也多些。我们摸索了一种新的修理工具,用来修0.5～10毫米小量块,经试用后,获得较满意的研合性、平面平行性、光洁度。工具结构如图1所示。

In the block repair, the size of 5.5 mm below the small block, the common method of repair is developed in the flat crystal or waste block. This method has so far been effective. However, a serious loss of research and easy bending deformation of the thin block, the more difficult to repair; the cost of more time. We explored a new repair tool for the repair of small blocks of 0.5 to 10 mm, after the trial, get more satisfied with the research, the plane parallelism, finish. Tool structure shown in Figure 1.