论文部分内容阅读
我厂的 K96铲床上,只附有升距 K 为3、5、7公厘的三种凸轮,而生产上却要制造大量升距 K 为1.5、2、2.5公厘的凸轮,所以要重新做一个很正确的凸轮,再利用这凸轮来铲铣刀。我们加工这凸轮的方法很简便,并且质量达到要求。1)凸轮的材料用低碳钢。2)利用铲床本身所附的凸轮,3、5、7公厘升距的凸轮都可以,我们用的是3公厘的。先将凸轮毛坯加工好,再装上铲床,将刀架扳一定的角
The K96 shoveling bed in our factory is only equipped with three kinds of cams with a lift of 3, 5 and 7 mm K, but a lot of cams with a lift of K of 1.5, 2 and 2.5 mm are produced in the production, Make a very correct cam, then use this cam to scoop the cutter. The way we process this cam is easy and the quality meets the requirements. 1) The material of the cam is made of mild steel. 2) Using the cam attached to the shovel itself, 3, 5, and 7 cm increments can be used. We use 3 mm. The first rough machining of the blank, and then mounted on the shovel bed, the turret to pull a certain angle