论文部分内容阅读
组合钢模板有它不易管理的难点:一是组合钢模板价值大,一次性投资多,周转使用30次,才能与木模板价值相等,要达到比木模施工有更大的收益,就必须增加周转使用次数;二是组合钢模板的品种、规格、零附件繁多,施工中需要量极大,作业中管理人员如果不重视管理,工人不注意爱护,损坏丢失将十分严重,造成周转次数利用率低下,就会导致经济价值比木模施工还要大;三是它组合配套性强,所有品种,规格都须齐备,但又不一定在所有的工程项目都用得上,所以不宜分散管理,否则就会是彼处积压用不上,此处急用又不足,如盲目增加购置,就会加大投资,经济上不上算;四是基本建设施工现场分散,流动性大,工人多,思想不易统一。施工管理人员一般只重视工程进度、质量,对钢模板在管理上重视较少。有的工程支模是甲班组,拆模时又换为乙班组。支模时不考虑将来怎样拆,拆模时又少考虑下次使用的便利,常常把拆下来的模板、零附件、支撑件混杂堆放,造成模板扭曲变形而损坏,使维修费用加大,影响使用。
Composite steel formwork has its difficult to manage: First, the value of the composite steel formwork is large, one-time investment is more, and turnover is used 30 times, in order to be equal to the value of the wood formwork. To achieve greater benefits than wood formwork construction, it must be increased. The number of turnovers; Second, the variety, specification, and accessories of the combined steel formwork are numerous, and the construction needs a great deal. If the management personnel in the operation do not pay attention to the management, the workers do not pay attention to the care, and the damage will be lost very seriously, resulting in the utilization of turnover times. Low, it will lead to greater economic value than the construction of wood mold; Third, it is a combination of strong, all varieties, specifications must be complete, but not necessarily in all projects are available, so it should not be decentralized management, Otherwise, there will be no backlog at this place, and there will be short-term use. If blindly increasing purchases, investment will be increased and the economy will not be counted. Fourth, the construction site is scattered, the mobility is large, and there are many workers. Not uniform. Construction managers generally only pay attention to the progress and quality of the project, and they pay less attention to the management of steel formwork. Some engineering support molds are Class A team, and they are changed to Class B team when demolishing. When the mold is not considered how to disassemble in the future, the convenience of the next use will be less considered when the mold is removed, and the disassembled templates, accessories, and supporting pieces are often mixed and piled up, resulting in distortion of the template and damage, which increases the maintenance cost. use.