【摘 要】
：
Ni-rich cathode material is one of the most promising materials for Li-ion batteries in electric vehicles.However,fading capacity,poor cyclic stability and high
【机 构】
：
College of Chemistry and Chemical Engineering,Xinxiang University,Xinxiang 453003,China;R&D Centre f
论文部分内容阅读
Ni-rich cathode material is one of the most promising materials for Li-ion batteries in electric vehicles.However,fading capacity,poor cyclic stability and high pH value are still major challenges,which suppress its practical application.In this study,spherical LiNi0.9-Co0.08Al0.02O2 powders with 0.4 wt％ TiO2 coating layer were prepared by impregnation-hydrolysis method.Scan-ning electron microscopy(SEM),high-resolution trans-mission electron microscopy(HRTEM)and X-ray diffraction(XRD)results show that TiO2 is uniformly coated on the surface of LiNi0.9Co0.08Al0.02O2 particle and slightly embedded into LiNi0.9Co0.08Al0.02O2 particles.After 100 cycles at 2.0C,0.4 wt％ TiO2-coated LiNi0.9-Co0.08Al0.02O2 electrode delivers much higher discharge capacity retention(77.0％)than the pristine LiNi0.9-Co0.08Al0.02O2 electrode(63.3％).The excellent cycling performance of 0.4 wt％ TiO2-coated LiNi0.9Co0.08Al0.02O2 electrode at a high discharge ratio is due to a TiO2 coating layer which can effectively reduce the direct contact between cathode material and electrolyte,suppress the oxidation of electrolyte,improve electrical conductivity of the electrode and increase the stability of the structure.
其他文献
CaTi2O5 was selectively prepared by a solvothermal process without template and surfactant.The phase of the as-prepared samples was determined by X-ray diffract
The effect of hydrogen addition on the deformation behavior of coarse-grained Ti-55 alloys(~20μm)was studied by uniaxial tension tests at high temperature.The elongation of hydrogenated Ti-55 titanium alloy firstly increases and then decreases with hydrog
Oxide pegging is a widely accepted mechanistic model explaining the reactive element effect on the improved adherence of scale.However,previous models for the oxide peg formation process have not considered the effects of more than one active element adde
Perovskite solar cells(PVSCs)have emerged as a promising photovoltaic technology and have attracted wide research interest due to their outstanding photovoltaic
For better performances of Ni-based catalysts at low temperatures,Ni/SiC catalyst doped with a little amount of additive La was successfully prepared.The catalytic CO methanation activity tests showed that 3%La-Ni/SiC catalyst was excellent at a low react
Gd2O3∶Tb3+ nanocrystal co-doped with Zn2+and Li+ was prepared by the combination of polyol and solid-phase methods.The synthesized nanoparticles were character
In this work,amido-graphene oxide(GO-NH2)loaded chitosan(CTS)composite material(CTS/GO-NH2)that acts as both the triboelectric and sensing film was prepared on rotary fan-shaped triboelectric nanogenerator for humidity detection.Comp
In situ cross-linking encapsulation has been demonstrated to be an efficient strategy for enhancing the humidity stability of perovskite solar cells(PSCs).In th
Most resistance-type humidity sensors exhibit negative humidity sensitivity,i.e.,their resistance decreases with a corresponding increase in humidity.This is primarily attributed to the dominant role of ionic conduction in adsorbed water.In this work,a hu
ZrB2-Al2O3 composite powders were synthesized at 1100℃ using a novel ZrB2 precursor and Al powders as raw materials.The final ZrB2-Al2O3 composite powders cons