论文部分内容阅读
一、气缸套阻水圈的正确安装气缸套阻水圈应装满气缸套上的防漏环槽,并高出约0.5毫米左右。阻水圈装入后,在环槽中显得太松或太低,可在环槽底部均匀地垫上适当的防漏纤维材料(如石棉线);如阻水圈高出环槽太多,往往在气缸套装入气缸体时,阻水圈被整齐地切掉一圈,或者很难压入气缸体,此时可预先用木锉将阻水圈修低后再装入。
First, the correct installation of the cylinder liner Water blocking the cylinder liner should be filled with a leak-proof ring groove on the cylinder sleeve, and about 0.5 mm higher. After the water stop ring is installed, it appears too loose or too low in the ring groove, and an appropriate leakproof fiber material (such as asbestos thread) can be uniformly padded on the bottom of the ring groove; if the water stop ring is too much above the ring groove, When the cylinder liner into the cylinder block, the water blocking ring is neatly cut off a circle, or difficult to press into the cylinder block, this time can be pre-cut with a wooden file to reduce the water blocking ring before reloading.