Deformation Localization and Shear Fracture of a Rapidly Solidified Al-Fe-V-Si Alloy at Elevated Tem

来源 :材料科学技术学报(英文版) | 被引量 : 0次 | 上传用户:huanzhonga
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
The tensile and fatigue behavior of a dispersoid strengthened, powder metallurgy Al-Fe-V-Si alloy at ambient and elevated temperatures was investigated. The results show that the strength and ductility of the alloy decrease significantly with increasing temperature and decreasing strain rate. Micro-structural examinations reveal that this change in mechanical behavior with increasing temperature is related to the mode of deformation of the alloy. Further observations show that localized shear deformation is responsible for the losses in both strength and ductility of the alloy at elevated temperature.
其他文献
随着中国经济的迅速发展,室内设计这个名词传入中国,中国建筑装饰行业逐步兴起,中国室内设计也迎来了新的春天,无论是设计的理念还是设计的手段都在和国际室内设计观念靠拢.
This paper discussed two methods to enhance the electrical conductivity of the carbon fiber(CF) electrically conductive concrete. The increase in the content of
Nanostructured yttria partially stabilized zirconia coatings were deposited by air plasma spraying with reconstituted nanosized powder. The microstructures and
本文来自于对活跃在SourceForge和GitHub上的项目的分析研究,同时我也在Twitter上向大家进行了调查,以免漏掉了很热门但是我却不知道的项目。
The mechanism responsible for the formation of recrystallization texture in cold-rolled Ti bearing interstitial free (IF) steel sheets was investigated using el
This Paper proposes a modified operation mode of batch extractive distillation with two reboilers.The separation of ethanol and water using as ethylene glycol i
To investigate the early-age behaviors of concrete under a restrained condition, a set of apparatus was developed. In this way, the tensile creep and other earl
在盐法破壁的基础上,添加质壁分离剂。当酵母浓度为10%、氯化钠浓度为5%时,添加5 mL乙酸乙酯,并在100℃下抽提2 h,可以增加核酸的提取率和纯度,使得提取率达到60%。
The electrical conductivity of Cu-10Ag in situ filamentary composite was studied during the deformation and annealing processes. The dependence of electrical re
Springback is caused by the redistribution of stress in sheet material after the tooling is removed. Precise prediction of sheet springback is very important in