【摘 要】
：
A paste-like self-flowing pipeline transportation backfilling technology with coal gangue as aggregate is proposed to remove the potential damage caused by coal
【机 构】
：
School of Resources and Safety Engineering,Suncun Coal Mine of Xinwen Coal Group
论文部分内容阅读
A paste-like self-flowing pipeline transportation backfilling technology with coal gangue as aggregate is proposed to remove the potential damage caused by coal gangue piles. As well, the difficult problems of recovering high quality safety coal pillars and deep mining of the Suncun Coal Mine (SCM), Xinwen Coal Group, Shandong are resolved. The physical-chemical properties of coal gangue, optimized proportion of materials, backfilling system and craft in the SCM were studied in the laboratory and then an industrial test was carried out on high quality coal pillars under a town. The results show that finely crushed kaolinized and fresh gangue with granularity less than 5 mm can be used as aggregate with fly ash to replace part of the cement and a compos-ite water reducer as an additive, accounting for 1.0%-1.5% of the total amount of cement and fly ash. The recommended proportion is I(cement):4(fly ash): 15(coal gangue), with a mass fraction of 72%-75%, theological paste-like properties and a strength of more than 0.7 MPa at 7 d. The sequence of adding cement, fly ash, water reducer and then coal gangue ensures that the suspended state of the slurry, reducing the wear and jam of pipelines. The working face is advancing continuously by the alternating craft of building block walls with coal gangue and backfilling mined-out gobs with paste-like slurry. The recovery rate is as high as 90% with a backfilling cost of 36.9 Yuan/t, good utilization of coal gangue and no subsidence on the surface. This technology provides a good theoretical basis and application experience for coal mines, cement backfilling with paste-like slurry.
其他文献
Semiclassical limit to the solution of transient bipolar quantum drift-diffusion model in semiconductor simulation is discussed. It is proved that the semiclass
Measurements were performed using Particle Image Velocimetry (PIV) to analyze the modification of flow by the combined effects of the rotation and the Reynolds
In this article, five kinds of silicon-containing steel sheets have been electrodeposited, and then immersed in a pure molten zinc bath at 450 ℃ for various pe
The anionic products from the reactions between metal(M=Ag,Au,Pd,Pt,Pb and Bi) vapour produced by laser ablation and hexafluorobenzene seeded in carrier gas(Ar)
In order to study stability control methods for a deep gate group under complex stresses, we conducted field investiga-tions and analyses of reasons for damage
This paper addresses the use of different slotted pores in rotating membrane emulsification technology.Pores of square and rectangular shapes were studied to un
Computational fluid dynamics (CFD) modeling of the complex processes that occur within the burner of a gas turbine engine has become a critical step in the desi
The Ni-B-Oδ and Ni-B-Zr-Oδcatalysts were prepared by the method of chemical reduction, and the deep removal of CO by selective methana-tion from the reformed
The mechanical behavior and microstructures of an Al-Zn-Mg-Cu-Cr aluminum alloy during multi-stage hot deformation were investigated by thermal stimulation test
Composite supports CeO2-ZrO2-Al2O3 (CZA) and CeO2-ZrO2-Al2O3-La2O3 (CZALa) were prepared by co-precipitation method. Palladium catalysts were prepared by impreg