Study on microstructure and mechanical properties of as-cast Mg-Sn-Nd alloys

来源 :稀土学报(英文版) | 被引量 : 0次 | 上传用户:ilove19830517
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Microstructure,tensile properties and compressive creep behaviors of Mg-(1.65-11.52) wt.% Sn-2 wt.% Nd alloys were studied in this paper.The microstructure of the as-cast Mg-Sn-Nd alloys consisted of dendritic α-Mg,Mg2Sn and Mg-Sn-Nd ternary phase containing rare earth element.The highest ultimate tensile strength of 140 MPa and percentage elongation after fracture of 9.7%,were achieved with a composition of Mg-8.23 wt.% Sn-2 wt.% Nd.The compressive creep resistance of Mg-8.23 wt.%Sn-2 wt.% Nd alloy was much better than other alloys at 200 ℃ for applied load of 35 MPa,which was mainly due to the formation of dispersive heat-resis tance Mg2Sn and Mg-Sn-Nd intermetallic compounds.
其他文献
An 8 mm-high NiCoCrAlYTa coating was epitaxially built-up on a directionally solidified (DS) Ni-based superalloy blade tip by electro-spark deposition. Epitaxia
A solute trapping model is developed based on a so-called solute drag treatment. By adopting a basic approach of phase-field models, and defining the free energ
Ti4+-mixed FePO4·xH2O precursor was prepared by co-precipitation method, with which Ti4+ cations were added in the process of preparing FePO4·xH2O to pursue a
A cerium-triethanolamine complex was obtained by the reaction of cerium(Ⅲ) nitrate and triethanolamine in ethanol solution.Spontaneous oxidation of cerium(Ⅲ)
The structural and electronic properties of bulk and (001) plane of TiC were investigated by the first-principles total-energy pseudopotential method based on d
Mechanical activation was used to improve the extraction of chromium in molten NaOH. It is observed that the extraction ratio reaches 97% after leaching for 200
High temperature tensile properties and microstructure evolutions of twin-roll-cast AZ31B magnesium alloy were investigated over a strain rate range from 10-3 t
The recent results on hydrothermal synthesis of mixed rare earth-alkali or ammonium fluorides were presented.The initial ratios of the starting materials,pH val
The brazing of 55% SiCp/A356 (volume fraction) composites in air using Zn-Al alloy as a filler metal was investigated. During the brazing process, ultrasonic vi