论文部分内容阅读
33.TCU更新(如图1159所示)(1)TCU CFC201F程序(固定接触点),如表87所示。(2)TCU CFC231F程序(SF2),如表88所示。(3)TCU CFC301F程序(SF3及以后),如表89所示。(4)TCU自学程序。(1)接触点自校准。将钥匙转至ON,等待至所有警告灯已检查确认,启动发动机等待约10s,转动钥匙至停止位置,等待至显示屏关闭重复操作4次(该操作必须在水温30~60℃,空调关闭时进行)
33.TCU update (as shown in Figure 1159) (1) TCU CFC201F program (fixed contact), as shown in Table 87. (2) TCU CFC231F program (SF2), as shown in Table 88. (3) TCU CFC301F program (SF3 and later), as shown in Table 89. (4) TCU self-study program. (1) contact point self-calibration. Turn the key ON and wait until all the warning lights have been checked and confirmed. Start the engine and wait for about 10 seconds. Turn the key to the stop position and wait for the display to turn off. Repeat for 4 times (This operation must be performed when the water temperature is between 30 and 60 ° C and the air conditioner is off get on)