【摘 要】
：
Light has been clinically utilized as a stimulation in medical treatment, such as Low-level laser therapy and photodynamic therapy, which has been more and more widely accepted in public. The penetration depth of the treatment light is important for preci
【机 构】
：
InstituteofBiomedicalEngineering,ChineseAcademyofMedicalScienceandPekingUnionMedicalCollege,Tianjin,
【出 处】
：
JournalofInnovativeOpticalHealthSciences
论文部分内容阅读
Light has been clinically utilized as a stimulation in medical treatment, such as Low-level laser therapy and photodynamic therapy, which has been more and more widely accepted in public. The penetration depth of the treatment light is important for precision treatment and safety control. The issue of light penetration has been highlighted in biomedical optics field for decades. However, quantitative research is sparse and even there are conflicts of view on the capability of near-infrared light penetration into brain tissue. This study attempts to quantitatively revisit this issue by innovative high-realistic 3D Monte Carlo modeling of stimulated light penetration within high-precision Visible Chinese human head. The properties of light, such as its wavelength, illumination profile and size are concern in this study. We made straightforward and quantitative comparisons among the effects by the light properties (i.e., wavelengths: 660, 810 and 980 nm; beam types: Gaussian and flat beam; beam diameters: 0, 2, 4 and 6 cm) which are in the range of light treatment. The findings include about 3% of light dosage within brain tissue; the combination of Gaussian beam and 810 nm light make the maximum light penetration (
其他文献
研究了压电陶瓷腔镜及其支架的机械共振,抑制了支架的本征振动,并设计了快速频响压电陶瓷腔镜,其最低共振频率为125kHz,对380-A.染料激光器进行了稳频,使其线宽减少到300kHz(p-p)。
对一定光纤材料及剖面型式,以图解方式绘出等色散系数点在结构参数平面内的分布图.它可用来选择光纤的芯径和相对折射率差等参数,以满足下述要求:工作波长为零色散,并由规定的色散允差(例如±3ps/km·nm)确定最可接受的结构允差.
本文叙述了在跨音速CO2-N2-He气流中，50升体积、千瓦均匀放电的气动技术。在气压高达150毛和电功率负载密度超过250千瓦/磅/秒的情况下，这种放电不靠管壁扩散，而自行扩散到整个体积范围的空间内。闭合循环流速为0.55磅/秒、尺寸为5.6×76×100厘米的激光放大器中通过17次，产生了19.1千瓦、波长为10.6微米的连续单模辐射，其电-光效率为24终。在气压为30乇时小信号增益是1.9%/厘米。
介绍了确定金属膜表面粗糙度的表面等离子激元光谱方法。测量了二种银膜(棱镜/银膜/空气和棱镜/LB膜/银膜/空气)在表面等离子激元激发条件下的光散射强度分布。通过与理论计算的拟合,得到了描写这二种银膜空气随机粗糙界面的特征参数。
用激光光压偏转原子束进行了锂同位素分离实验。准直比为450:1的原子束装置,炉温600℃时发生的原子束的数密度为109个原子/厘米3,可调谐连续染料激光经柱面镜系统扩束后与原子束正交。激光线宽6兆赫,在1厘米长的交叉区域内功率密度为70毫瓦/厘米2。当激光频率对准7Li22P3/2F=3←22S1/2F=2跃迁时,7Li原子从束中偏转。被偏转的原子中几乎不合6Li,为非常纯的7Li。当激光频率对准6Li和7Li22P←22S跃迁的其它超精细跃迁时,未看到明显的偏转,这是由于基态超精细能级的光泵浦效应所致。
采用简便的染料激光器速率方程组计算了输出耦合对器件阈值泵浦速率、输出功率和量子效率的影响.取得了有益的结果,对设计氙灯泵浦染料激光器和连续染料激光器有一定参考价值.
利用液晶空间光调制器对高斯光束进行相位调制后可生成涡旋光束。因涡旋光束本身具有轨道角动量，酵母细胞被光阱捕获后会绕其中心旋转，对酵母细胞旋转的时序信号图进行傅里叶变换后可测出酵母细胞在光阱中的旋转角速度。详细讨论了酵母细胞旋转角速度随激光功率、拓扑荷以及捕获高度的变化关系。实验结果表明，酵母细胞的旋转角速度与激光功率成正比，与拓扑荷的平方成反比；捕获高度在14 μm时角速度达到最大值；细胞在涡旋光阱中的旋转方向可由拓扑荷的符号决定，正号为逆时针旋转，负号为顺时针旋转。此实验结果有望应用在细菌鞭毛马达力矩的
A hollow-core fiber based on photonic quasicrystal arrays is theoretically proposed for high-quality light wave propagation with high polarization maintaining performance and low nonlinearity. This fiber, called hollow-core photonic quasicrystal fiber (HC
现有基于热光源的关联成像主要是针对透射型物体，这样可简化关联成像分析过程。然而对于成像的实际应用，比如遥感技术，反射型物体将具有更大的实用价值。基于非相干均亮的热光源，对反射型物体的高阶关联成像进行了研究，推导出其高阶反射关联成像的关联函数、可见度及信噪比的解析式；对比二阶反射关联成像，讨论阶数对关联成像性能的影响。研究结果表明，对于反射型物体的关联成像，随着阶数的增加，成像的可见度得到提高，但信噪比下降，同时能够通过增加测量次数增加成像的信噪比。
据美国电报电话公司长线部订约人宣称，西部电器公司最近贏得1450公里光纤系统的投标,因为这种系统使用了“最先进技术所提供的最便宜的系统”。长线部拒绝直说西部电器公司的投标是成本最低的,技术先进却是无疑的。