论文部分内容阅读
研究了阴离子表面活性剂十二烷基硫酸铵(ADS)在弱碱性铜抛光液中对晶圆平坦化效果的影响。对不同质量分数的阴离子表面活性剂ADS下的抛光液表面张力、铜去除速率、抛光后铜膜的碟形坑高度、晶圆片内非均匀性和表面粗糙度进行了测试。实验结果表明,当阴离子表面活性剂ADS的质量分数为0.2%时,抛光液的表面张力降低,铜的去除速率为202.5 nm·min~(-1),去除速率片内非均匀性减小到4.15%,抛光后铜膜的碟形坑高度从132 nm降低到68.9 nm,表面粗糙度减小到1.06 nm。与未添加表面活性剂相比,晶圆表面的平坦化效果得到改善。
The effect of anionic surfactant sodium lauryl sulfate (ADS) on wafer planarization in weakly alkaline copper slurry was investigated. The surface tension, copper removal rate, disc height of the polished copper film, wafer inhomogeneity and surface roughness of the polishing solution with different mass fractions of anionic surfactant ADS were tested. The experimental results show that when the mass fraction of anionic surfactant ADS is 0.2%, the surface tension of polishing solution decreases, the removal rate of copper is 202.5 nm · min -1, the in-chip nonuniformity of removal rate decreases to 4.15%. After polishing, the height of the disc pit decreases from 132 nm to 68.9 nm, and the surface roughness decreases to 1.06 nm. The planarization effect of the wafer surface is improved compared to the non-addition of surfactant.