【摘 要】
：
Shallow hydrofoils are known to produce lower lift in normal operating conditions in comparison with deep hydrofoils. However, the maximum lift capability of shallow hydrofoils at moderate speeds, which is important for transitional regimes of hydrofoil b
【机 构】
：
Department of Mechanical Engineering, The University of Idaho, Moscow, Idaho, USA;School of Mechanic
论文部分内容阅读
Shallow hydrofoils are known to produce lower lift in normal operating conditions in comparison with deep hydrofoils. However, the maximum lift capability of shallow hydrofoils at moderate speeds, which is important for transitional regimes of hydrofoil boats, is studied insufficiently. In this work, two-dimensional flow around a high-lift hydrofoil at a moderate Froude number is numerically simulated in a broad range attack angles up to the stall occurrence in both single-phase fluid and in the vicinity of free surface. It is found that nearly the same maximum lift coefficient can be produced by the shallow foil in the modeled condition as by the deep foil, but much higher attack angle is required near the free surface, which also results in larger drag. Additionally, it is shown that higher Reynolds numbers lead to higher lift coefficients, especially at large attack angles.
其他文献
Investigated the effect of an addition of CaF2 on the crystallization of a glass-ceramic with abrasion resistance. X-ray diffraction, differential thermal analysis and scanning electron microscopy were used to determine the effect. The results showed that
The movement principle of sidewalls and floor of extraction opening is analyzed, it is found that floor heave not only has something to do with the floor strata, but sidewalls. The effect of sidewall anchor and corner anchor is studied, the mechanical pri
Based on continuum mechanics and rock dynamics, analyzed the micro-structure damage of rock and the impulsive effect under high pressure water jet and developed the dynamic model. Further, on the assumption of that rock was homogeneous and isotropic, a co
A system of on-line contamination detecting in hydraulic oil based on silting principle is accomplished, where, metal filter membrane as detector, solenoid as active force to propel piston to blotter and gain differential pressure, step motor drives the m
By using the Radar penetrating technology and numerical simulations, the fractured zone could be easily determined. Both wall fractured zone and mining action of coal seam roadway were considered, and the bolt reinforcing criteria for wall including low l
It is well known that the formation permeability is not a constant but a function of the in-situ stress environment. This study has been primarily carried out numerically, and to a certain extent, in the field. However, since the rock properties are gener
The structure and principle of the GMM actuator and the new nozzle flapper valve with the GMA were presented. Based on the axis-symmetric FEM model of the GMA,driving magnetic field was computed. And the field distribution for different input currents and
An assistant surface was constructed on the base of boundary that being automatically extracted from the scattered data. The parameters of every data point corresponding to the assistant surface and their applied fields were calculated respectively. In ev
Coal forming environments in the tectonically controlled intermontane Stephanian Cévennes coal basin (Massif central, France) show a complex interelationship between structural and sedimentological features. The study of the general structural features an
Cavitating bubbly flows can form in separated flows and shear layers leading to local regions high vapor void fraction, and these flows often exhibit periodic shedding of vaporous clouds. Historically, the presence of a liquid re-entrant flow, driven by t