论文部分内容阅读
日本贾派克斯电解加工机床采用非线性电解液、低压混气,并有液温、浓度控制装置,加工形状精度为0.1～0.15毫米,重复精度为0.03～0.06毫米,加工速度通常为0.4～3毫米,加工表面光洁度通常为2～7μR最大 (约相当▽8～7)。由于它采用低液压(5公斤/厘米~2以下)加工,能得到细微的加工形状,并且对电极的刚性要求低,故能使用石墨电极,电极前端使用Ag—W、Cu—W、Cu—C等烧结合金。该公司制出了加工石
JAPEX Japan electrolytic machining machine using non-linear electrolyte, low pressure mixed gas, and liquid temperature, concentration control device, the processing of shape accuracy of 0.1 to 0.15 mm, repeat accuracy of 0.03 to 0.06 mm, the processing speed is usually 0.4 to 3 Mm, the processing surface finish is usually 2 ~ 7μR maximum (about the same ▽ 8 ~ 7). Because of its low hydraulic pressure (5 kg / cm 2 or less) processing, can get the subtle machining shape, and the low rigidity of the electrode, it can use graphite electrode, the electrode front end using Ag-W, Cu-W, Cu- C and other sintered alloys. The company made the processing stone