论文部分内容阅读
我隊在加工合金鑽頭時,採用了一種镶嵌的方法來镶鑽頭上的合金,不但提高工效,而且保證了合金出刃的正確。這種镶嵌的具體作法是:首先按鑽頭的合金數.規格以及合金出刃的要求設計一個鑽套(图1),将它置於筒狀鑽頭上,鑽頭下部支持在特製的體垫上(图2),再按图3所示的辦法將鑽頭卡好,即可放鑽床上加工合金孔,孔的直徑及深度按合金規格及合金出刃要求决定。由於有鑽套在上面,加工時
My team in the processing of alloy drill, the use of a mosaic method inlaid the alloy head, not only improve work efficiency, but also to ensure that the alloy is correct. The specific practice of this mosaic is: first, according to the alloy number of the drill bit specifications and requirements of alloy cutting edge design a drill sleeve (Figure 1), it is placed on the cylindrical drill bit, the lower part of the drill supported in a special body pad (Figure 2 ), And then press the method shown in Figure 3 will drill a good card, you can put the bed processing alloy hole drilling diameter and depth of the hole by the alloy specifications and the requirements of the blade out. Due to the drill sleeve in the above, processing