Solderability and intermetallic compounds formation of Sn-9Zn-xAg lead-free solders wetted on Cu sub

• 出 处: Rare Metals
• 发表日期: 2009年06期
• 关键词: intermetallic solder eutectic adding nodular interfacial fluidity likely wetting

The eutectic Sn-9Zn alloy was doped with Ag (0 wt.%-1 wt.%) to form Sn-9Zn-xAg lead-free solder alloys. The effect of the addition of Ag on the microstructure and solderability of this alloy was investigated and intermetallic compounds (IMCs) formed at the solder/Cu interface were also examined in this study. The results show that, due to the addition of Ag, the microstructure of the solder changes. When the quantity of Ag is lower than 0.3 wt.%, the needle-like Zn-rich phase decreases gradually. However, when the quantity of Ag is 0.5 wt.%-1 wt.%, Ag-Zn intermetallic compounds appear in the solder. In particular, adding 0.3 wt.% Ag improves the wetting behavior due to the better oxidation resistance of the Sn-9Zn solder. The addition of an excessive amount of Ag will deteriorate the wetting property because the glutinosity and fluidity of Sn-9Zn-(0.5, 1)Ag solder decrease. The results also indicate that the addition of Ag to the Sn-Zn solder leads to the precipitation of ε-AgZn3 from the liquid solder on preformed interfacial intermetallics (Cu5Zn8). The peripheral AgZn3, nodular on the Cu5Zn8 IMCs layer, is likely to be generated by a peritectic reaction L + γ-Ag5Zn8 →ε-AgZn3 and the following crystallization of AgZn3.

The effect of the addition of Ag on the microstructure and solderability of this alloy was (0 wt.% - 1 wt.%) To form Sn-9Zn-xAg lead-free solder alloys The results show that, due to the addition of Ag, the microstructure of the solder changes. When the quantity of Ag is less than 0.3 wt.% (IMCs) formed at the solder / Cu interface was also examined in this study However, when the quantity of Ag is 0.5 wt.% - 1 wt.%, Ag-Zn intermetallic compounds appear in the solder. In particular, adding 0.3 wt.% Ag improves the wetting behavior due to the better oxidation resistance of the Sn-9Zn solder. The addition of an excessive amount of Ag will deteriorate the wetting property because of glutinosity and fluidity of Sn-9Zn- (0.5,1) Ag solder decrease. The results also indicate that the addition of Ag to the Sn-Zn solder leads to the precipitation of ε-AgZn3 from the liquid solder on preformed interfacial intermetallics (Cu5Zn8). The peripheral AgZn3, nodular on the Cu5Zn8 IMCs layer, is likely to be generated by a peritectic reaction L + γ-Ag5Zn8 → ε-AgZn3 and the following crystallization of AgZn3.