论文部分内容阅读
(2)测量微处理器检测引脚电压,确定是否进入保护状态发生故障时,通过测量微处理器保护检测引脚电压是否产生翻转,同时测量待机控制输出引脚电压,来判断微处理器是否进入保护状态。如测量图3(b)上的
(2) measure the microprocessor pin voltage measurement to determine whether the state of protection into failure, by measuring the microprocessor pin voltage detection protection flip, while measuring the standby control output pin voltage to determine whether the microprocessor Into the protection state. As measured on Figure 3 (b)