论文部分内容阅读
(一)取材:取直径外口1cm的竹管毛笔的竹笔帽亦可),其内口约0.6cm左右(图1),长度不限.(二)制法:在竹管的某一端用快科的小刀削一斜形(图2),然后在斜形的背后钻一小孔;由小孔通向尖端之处以小刀尖剥一裂缝,其缝不宜太宽,也不宜太靠拢(图3);再用大约3cm长的竹皮由所削的倾斜处塞入管内(图4),塞入竹皮时应集中在竹管的中
(A) drawn: Take the diameter of the mouth 1cm bamboo pen bamboo hat can also), its mouth about 0.6cm (Figure 1), the length is not limited. (B) system of law: at one end of the bamboo tube The knife of a quick division is cut into a bevel shape (Figure 2), and then a small hole is drilled behind the bevel. The small hole leads to the tip where a crack is peeled off with a sharp knife tip. The seam should not be too wide nor too close 3); then use about 3cm long bamboo skin into the tube from the cut slope (Figure 4), into the bamboo skin should be concentrated in the bamboo tube