论文部分内容阅读
Copper matrix composites have received more attentions as possible candidate for thermal and electrical conductive materials to be used in electrical contact applications. In this study, five-layered Cu/YSZ(yttria-stabilized zirconia) functionally graded material(FGM) and copper matrix composite specimens containing 3 and 5 vol% YSZ particles plus pure Cu specimen were synthesized using powder metallurgy(PM) route and spark plasma sintering(SPS)consolidation process. The microstructural and some physical, mechanical features of all specimens were characterized.Microscopic examinations showed that ultrafine YSZ particles were distributed in the copper matrix almost homogeneously. An appropriate interface was observed at each layer of FGM. The density measurement indicated that the graded structure of the composite could be well densified after the SPS process. The microhardness values of various layers of Cu/YSZ FGM specimen were gradually altered from 56.3(pure copper side) to 75.2 HV(Cu-5 vol% YSZ side). The increase of YSZ content resulted in a decrease in electrical conductivity. Additionally, thermal conductivity of Cu/YSZ FGM specimen [308.0 W/(m K)] was determined to be higher than that of the Cu-5 vol% YSZ composite specimen [260.7 W/(m K)]. Accordingly, it can be concluded that the Cu/YSZ FGM can be a good candidate for the electrical applications, like sliding electrical contacts, where different material characteristics in the same component are required.
Copper matrix composites have received more attentions as possible candidate for thermal and electrical conductive materials to be used in electrical contact applications. In this study, five-layered Cu / YSZ (yttria-stabilized zirconia) functionally graded material (FGM) and copper matrix composite specimens containing 3 and 5 vol% YSZ particles plus pure Cu specimen were synthesized using powder metallurgy (PM) route and spark plasma sintering (SPS) consolidation process. The microstructural and some physical, mechanical features of all specimens were characterized. Microroscopic examinations showed that that The appropriate interface was observed at each layer of FGM. The density measurement indicated that the graded structure of the composite could be well after the SPS process. The microhardness values of various layers of Cu / YSZ FGM specimen was changed from 56.3 (pure copper side) to 75.2 HV ( Cu-5 vol% YSZ side). The increase of YSZ content resulted in a decrease in electrical conductivity. Was thermal conductivity of Cu / YSZ FGM specimen [308.0 W / (m K)] was determined to be higher than that of the Cu-5 vol% YSZ composite specimen [260.7 W / (m K)]. It can be concluded that the Cu / YSZ FGM can be a good candidate for the electrical applications, like sliding electrical contacts, where different material characteristics in the same component are required.