【摘 要】
：
The Mg0.9Ti0.1Ni1-xPdx (x= 0,0.05, 0.1, 0.15) hydrogen storage electrode alloys were prepared by mechanical alloying. The main phases of the alloys were determi
【机 构】
：
Dalian Institute of Chemical Physics,Graduate School of Chinese Academy of Sciences,Institute of New
论文部分内容阅读
The Mg0.9Ti0.1Ni1-xPdx (x= 0,0.05, 0.1, 0.15) hydrogen storage electrode alloys were prepared by mechanical alloying. The main phases of the alloys were determined as amorphous by X-ray diffraction(XRD). The corrosion potentials of the alloys were measured by open circuit potential measurements and the values are -0.478, -0.473, -0.473 and -0.471 V (vs Hg/HgO electrode) for x=0, 0.05, 0.1, 0.15, respectively. The corrosion currents of the studied alloys were obtained by non-linear fitting of the anodic polarization curve using Bulter-Volmer equation and Levenberg-Marquardt algorithm, which were obtained after different cycles.The initial corrosion currents of the alloys are decreased with the increasing of Pd content. The increasing of Pd content in the alloys inhibits the corrosion rates of the electrode alloys with the progress of cycle number. The electrochemical impedance spectroscopy(EIS) was conducted after open circuit potential of the alloys stabilizing. The impedance data fit well with the theoretical values obtained by the proposed equivalent circuit model. The corrosion resistances and the thickness of surface passive film of the alloys, which were deduced by the analyses of EIS, are enhanced with the increasing of Pd content in the alloys, which are consistent with the results of corrosion rates obtained from anodic polarization measurements.
其他文献
High density polyethylene filled with conductive carbon black was prepared by conventional melt-mixing method. The effect of unidirectional pressure on the cond
The electrical and thermal performances of a simulated 60 kW Proton Exchange Membrane Fuel Cell (PEMFC) cogeneration system are first analyzed and then strategi
The semi-continuous seeded emulsion copolymerization of vinyl acetate and butyl acrylate was carried out with hydroxyethyl cellulose as a colloid stabilizer. Th
A new type of transferring structure for steel reinforced concrete (SRC) beams is used in high building. The pushover analysis method was used to study the fail
Reinforced concrete structural elements with box section are commonly used in the horizontal and vertical structure of bridges. The reinforced concrete structur
MgTiO3 precursor was mechanochemically synthesized by high-energy ball milling of MgO and TiO2. The sintering characteristic of the resulted MgTiO3 precursor wa
After a review of the tufting industrys development, and a brief introduction to available systems for producing patterned tufted carpets, the principle of ICN
Hydroxyapatite coatings were prepared on titanium substrate by electrochemical deposition technology, in which the electrolyte was 0.042 mol/L Ca(NO3)2 and 0.02
In this note, a robust adaptive control scheme is proposed for a class of nonlinear systems that have unknown multiplicative terms. Unlike previous results, exc
Electrochemical behaviors of laser-welded Ti-50.6%Ni(mole fraction) shape memory alloy and the base metal in 0.9% NaCl solution were investigated by electrochem