【摘 要】
：
Large-scale flapping-wing flying robotic birds have huge application potential in outdoor tasks,such as military reconnaissance,environment exploring,disaster rescue and so on.In this paper,a multiple modes flight control method and system are proposed fo
【机 构】
：
School of Mechanical Engineering and Automation,Harbin Institute of Technology,Shenzhen 518055,China
论文部分内容阅读
Large-scale flapping-wing flying robotic birds have huge application potential in outdoor tasks,such as military reconnaissance,environment exploring,disaster rescue and so on.In this paper,a multiple modes flight control method and system are proposed for a large-scale robotic bird which has 2.3 m wingspan and 650 g mass.Different from small flapping wing aerial vehicle,the mass of its wings cannot be neglected and the flapping frequency are much lower.Therefore,the influence of transient aerodynamics instead of only mean value are considered in attitude estimation and controller design.Moreover,flight attitude and trajectory are highly coupled,and the robot has only three actuators----one for wings flapping and two for tail adjustment,it is very difficult to simultaneously control the attitude and position.Hence,a fuzzy control strategy is addressed to determine the command of each actuator by considering the priority of attitude stabilization,tra-jectory tracking and the flight safety.Then,the on-board controller is designed based on Free-RTOS.It not only satisfies the strict restrictions on mass,size,power and space but also meets the autonomous,semi-autonomous and manual flight control requirements.Finally,the developed control system was integrated to the robotic prototype,HIT-phoenix.Flight experiments under dif-ferent environment conditions such as sunny and windy weather were completed to verify the con-trol method and system.
其他文献
The deviations of trajectory and attitude angle for internal store separation are evaluated by two wind tunnel test methods.One is the Freedrop Test (FDT),which is known as unsteady and time-dependent method of scaled model.The other is the Captive Trajec
Flow separation due to shock wave/boundary layer interaction is dominated in blade passage with supersonic relative incoming flow,which always accompanies aerodynamic perfor-mance penalties.A loss reduction method for smearing the passage shock foot via S
The thermal radiation of micron-sized condensed phase particles plays a dominant role during the heat transfer process in aluminized Solid Rocket Motors (SRMs).Open research mainly focuses on the radiative properties of alumina particles while the study c
Aviation and aerospace system are typical Phased-Mission Systems (PMSs) featured with varying configuration,phased load condition and cross phase failure correlation.The coupling effect of Functional Dependency (FDEP) and Physical Dependency (PDEP) has a
Tuned Mass Dampers (TMDs) are often attached to a main structure to reduce vibra-tion,and the TMDs\' positions are important to affect the structural dynamic performance.How-ever,the TMDs\' positions and the material layout of the structure act on eac
For a homogeneous,continuous,and isotropic material whose constitutive relationships meets with the Ramberg-Osgood law (R-O law),the energy in the elastoplastic indentation with a ball indenter was theoretically analyzed,and the proportional superposition
Partial surge is a type of instability inception in transonic compressors and occurs in the form of axisymmetric low-frequency disturbances localized in the hub region.Previous studies illus-trate that the frequency of partial surge is set by the Helmholt
This paper studies on a division method of the whole aeroengine loading spectrum flight mission segment and rotor speed mission segment,which is based on the actual flight actions and related to the flight operations of aeroengine and is suitable for the
This paper presents a novel Fault Tolerant Control (FTC) scheme based on accelerated Landweber iteration and redistribution mechanism for a horizontal takeoff horizontal landing reu-sable launch vehicle (RLV).First,an adaptive law based on fixed-time non-
With the rapid growth of flight flow,the workload of controllers is increasing daily,and handling flight conflicts is the main workload.Therefore,it is necessary to provide more efficient conflict resolution decision-making support for controllers.Due to