论文部分内容阅读
我矿选矿厂4号皮带运输机的PM350减速机,历来使用机油润滑,由于漏油严重,在减速机外壳上以及机座上积满了厚厚的一层油垢,既影响了文明生产和设备完好率,又浪费了不少机油。1979年11月7日我矿推广二硫化钼小组对该减速机应用二硫化钼挤压成膜进行试验。具体做法如下: (1) 解体减速机,放出并回收减速箱内的机油。(2) 检查滚动轴承,并用汽油清洗干净。(3)清除齿轮表面锈斑和油污,先用细纱布逐齿擦锈,再用汽油擦洗,使齿面上没有一点油污。(4) 清
PM350 gearbox of belt conveyor No.4 in our ore beneficiation plant has always used oil lubrication. Due to the serious oil spill, a thick layer of grease on the reducer housing and on the machine base has affected the production and equipment of civilization Rate, but also a lot of waste of oil. November 7, 1979 I mine promotion of molybdenum disulfide team applied to the reducer molybdenum disulfide film extrusion test. Specific practices are as follows: (1) disintegration reducer, release and recovery gearbox oil. (2) Check the rolling bearings, and clean with gasoline. (3) remove the rust and oil stains on the surface of the gear, the first scrape the teeth with fine gauze scraping rust, then scrub with gasoline, so that there is no tooth surface oil. (4) clear