【摘 要】
：
For 308L and 347L weld metals of austenitc stainless steels (ASS), hydrogen induced cracking (HIC) occurred during dynamically charging under constant load. The
【机 构】
：
Department of Welding Research,Department of Materials Physics
【基金项目】
：
This project was supported by the Special Fund for the Major State Basic Research projects
论文部分内容阅读
For 308L and 347L weld metals of austenitc stainless steels (ASS), hydrogen induced cracking (HIC) occurred during dynamically charging under constant load. The threshold stress intensity for HIC, KIH, decreased linearly with the logarithm of the concentration of diffusible hydrogen Co in the weld metals and the rolled plate of type 304L ASS, i.e.,KIH=85.2--10.7ln Co (308L), KIH=76.1-9.3ln C0(347L), and KIH=91.7--10.1ln C0(304L). The fracture mode for HIC in the three type of ASS changed from ductile to brittle with the decrease in the applied stress intensity KI or/and the increase in Co. The boundary line between ductile and brittle fracture surfaces was KI-54+25exp(-Co/153)=0.
其他文献
The low-voltage-electromagnetic forming was applied to powder compaction. A series of experiments was performed to compact aluminum, copper and tin powders in a
The martensite structure in Cu-25Al-3Mn alloy and its thermal cycling and aging behavior are studied. It is convinced that the M2H martensite can be obtained by
After research on a 2000t/h subcritical forced-circulation balanced v entilation were applied boiler and the structure and operation of its auxiliary system bui
The influence of Cu dopant (x) and sintering temperature (Ts) on the transport properties of La2/3 Ca1/3 Mn1- xCuxO3 series samples prepared by Sol-Gel techniqu
Three-layer feedforward networks have been widely used in modeling chemical engineering processes and prior-knowledge-based methods have been introduced to impr
Application of the Semenov theory of spontaneous ignition to evaluation of the critical temperature (Tc′) in thermal explosion (TE) synthesis was conducted wit
By using thermal simulation technique, the conventional canned-forging process of TiAl based alloy was studied. The effect of can parameters on the microstruct
To solve the problems of EDM when using the ordinary fluid and mold manufacturing, this paper provides the orthogonal experiment in the suspended powder fluid,
By using such flier-plate material, quasi-isentropic compression can be realized. Based on it,hypervelocity launching is further accomplished. As a result, an e
The transparent anatase TiO2 nanometer thin films were prepared by the sol-gel method on soda-lime glass. X-ray diffraction, thermal analysis and UV-visible spe