论文部分内容阅读
A series of experiments of the premixing stage of fuel-coolant interactions (FCI), namely the particles falling into water, were carried out. The force on the particles during the course of falling has been studied. The dropping character of hot particle was influenced by three main parameters, i.e., particle temperature, particle diameter and coolant subcooling that varied over a wide range. A high-speed camera recorded the falling speed of the particle and the moving curves were obtained. The experimental results showed that for the film boiling on the surface of particle and water, the temperature increase of either particle or coolant would slow down the particle falling velocity. The falling velocity of particle in small diameter is lower than that of the bigger particle. The present work can provide an experimental foundation for further investigation of high-speed transient evaporation heat transfer.
A series of experiments of the premixing stage of fuel-coolant interactions (FCI), namely the particles falling into water, were carried out. The force on the particles during the course of falling has been studied. The dropping character of hot particle was influenced by three main parameters, ie, particle temperature, particle diameter and coolant subcooling that varied over a wide range. A high-speed camera recorded the falling speed of the particle and the moving curves were. The experimental results showed that for the film boiling on the surface of particle and water, the temperature increase of either particle or coolant would slow down the particle falling velocity. The falling velocity of particle in small diameter is lower than that of the bigger particle. The present work can provide an experimental foundation for further investigation of high-speed transient evaporation heat transfer.