论文部分内容阅读
Diatomite was used as raw material to prepare sodium silicate with a modulus of 3.1 by alkalidissolution method and the resulted sodium silicate solution was employed as a precursor. Methyl methacrylate monomers were introduced in wet gels through solution-immersion, and upon heating at 70 ℃, the mesoporous surfaces throughout the skeletal framework were coated with the polymer layer. PMMA modified silica aerogels were successfully synthesized via ambient pressure drying. The properties were investigated by FTIR, NMR, TGA, nitrogen adsorption-desorption, FESEM and nano-indentation, etc. Results indicate that with the increasing of PMMA incorporated into silica aerogels, the bulk density and the BET surface area increase, the porosity decreases. Through the observation of FESEM, it is found that the interconnecting pores and the big pores add, the pore size distribution expands from 5-17 to 28-150 nm. By comparison, the PMMA modified silica aerogels achieve a 52-fold increase in hardness and a 10-fold increase in modulus.
Diatomite was used as raw material to prepare sodium silicate with a modulus of 3.1 by alkalidissolution method and the resulted sodium silicate solution was employed as a precursor. Methyl methacrylate monomers were introduced in wet gels through solution-immersion, and upon heating at 70 ° C, the mesoporous surfaces throughout the skeletal framework were coated with the polymer layer. PMMA modified silica aerogels were successfully synthesized via ambient pressure drying. The properties were investigated by FTIR, NMR, TGA, nitrogen adsorption-desorption, FESEM and nano-indentation, etc. Results indicate that with the increasing of PMMA incorporated into silica aerogels, the bulk density and the BET surface area increase, the ratio decreases. The filtration of the interconnecting pores and the big pore add, the pore size distribution expands from 5-17 to 28-150 nm. By comparison, the PMMA modified silica aerogels achieve a 52-fold increase in hardn ess and a 10-fold increase in modulus.