论文部分内容阅读
对硬盘进行分区可谓是一件十分简单的事情,几乎所有的电脑爱好者们都会使用FDISK这个命令.但有时要对硬盘分区却又非常麻烦,比如我的金长城S400 466M微机装有一个420M的硬盘,出厂时只划分了一个C:逻辑驱动器,而厂商已经在硬盘上预装了约140多兆的原版软件.如果想对这样装满数据的硬盘进行分区,那就必须用很多软盘来备份.问题是不要说我手上没有这么多的磁盘,就算有,要备份一百多兆软件(分完区后还得恢复回硬盘)也够让人头疼的了.而且拷贝过的软件在感觉上总归不那么”正宗”了.为了解决这个难题,我想了不少办法.后采使用MSDOS6.22硬盘压缩软件DRVSPACE中的用硬盘自由空间来创建新的压缩驱动器功能来对硬盘“分
Partitioning a hard drive can be described as a very simple matter, almost all computer enthusiasts will use FDISK this command, but sometimes partition the hard disk but very troublesome, such as my Gold Great Wall S400 466M microcomputer equipped with a 420M Hard disk, the factory is only divided into a C: logical drive, and manufacturers have been pre-installed on the hard disk about 140 megabytes of the original software.If you want to partition such a hard disk full of data, it must be used to back up a lot of floppy disks The problem is not to say that I do not have so much disk, even if there is, to backup more than 100 megabytes of software (after the sub-area have to restore back to the hard disk) is enough headache. And copied software in the sense On the total less “authentic.” In order to solve this problem, I think a lot of ways.Second adopt the MSDOS6.22 hard disk compression software DRVSPACE with hard disk free space to create a new compressed drive function to the hard disk "points