【摘 要】
：
Microstructure characterization,corrosion behavior,and electrochemical properties of magnesium anode materials containing 1-3 wt.％ Sn in AZ61 alloy were studied
【机 构】
：
School of Materials and Chemical Engineering
论文部分内容阅读
Microstructure characterization,corrosion behavior,and electrochemical properties of magnesium anode materials containing 1-3 wt.％ Sn in AZ61 alloy were studied by optical microscopy,X-ray diffraction (XRD),scarming electron microscopy (SEM),and energy-dispersive spectroscopy (EDS),constant current method,potential polarization,and drainage.The results showed that amount of Mg2Sn phase increased,and recrystallization ratio of Sn-contained Mg alloys during rolling process was improved with increasing of Sn content.This resulted in uniform and refined grains.The results also demonstrated that discharge potential was improved and hydrogen release rate was reduced with the addition of Sn.As the current density increased,the release hydrogen rate was rising,owing to negative variance effect of magnesium alloys.The current efficiency gets to 87％ at 20 mA/cm2.The main components of the corrosion products are easy-to-peel-off MgO and Al2O3 that can lead to more negative and stable work potential and accelerate battery reaction continuously.
其他文献
The microstructural evolution and interfacial reaction of the Au/Sn/Au/Sn/Au/Sn/Au couples were investigated during annealing at 453,523,and 543 K for up to 240
The microstructure of the as-cast 7A55 aluminum alloy and its evolution during homogenization were investigated by means of optical microscopy (OM),scanning ele
In order to verify the validity of finite element numerical simulation method for asphalt mixture,which consists of aggregates,mastic (where mastic is a kind of
The polycrystalline samples of Pr0.45(Ca1-xSrx)0.55MnO3 (x =0.0,0.2,0.4,0.6) were prepared by solid-state reaction.Influence of Sr2+ substitution for Ca2+ at A
To denoise the diffusion weighted images (DWIs) featured as multi-boundary,which was very important for the calculation of accurate DTIs (diffusion tensor magne
In this work,a facile route using a simple solvothennal reaction and sequential heat treatment process to prepare porous Y2O3 microcubes is presented.The as-syn
A new method was presented to determine the safety factor of wall stability against overturning based on pseudo-dynamie approach.In this time-dependent method,t
始于2007年的全球金融危机，不仅使金融市场遭受了巨大损失，也使全球两大会计准则制定机构--国际会计准则理事会和美国财务会计准则委员会承受了来自各方面的压力，促使其着手修订
Zn-5wt％ Al eutectic alloy was directionally solidified with different growth rates (5.32-250.0 tm/s) at a constant temperature gradient of 8.50 K/mm using a Brid
Ipex 2014即将在英国伦敦开幕，展示新的技术格局，印刷企业都在多方了解业况。那么，印刷企业到底该关注什么呢？