论文部分内容阅读
水丸又称水泛丸,在制备过程中起模是关键工序,模子的形状及粒度直接影响成品的圆整度和规格。目前起模的方法大致有:用泛丸匾手工起模。用包衣锅起模和颗粒过筛起模等三种方法,但都存在费时费力、粒度差较大或不够圆整等缺点。通过实践我们摸索了一种新的起模方法,即采用包衣锅在泛丸成型阶段进行起摸。其方法如下:当锅中首批所泛丸子成型至丸重规定规格时,适当增撒一次性药粉量,并停喷粘合剂,任其自然转动4～5分钟,使药粉不能全部粘着在丸子表面而形成小颗粒并沉于锅底。此时停止用手操翻丸子,
Pellets are also called water pan pellets. Molding is the key procedure in the preparation process. The shape and grain size of the mold directly affect the roundness and specifications of the finished product. At present, the methods for removing molds are roughly as follows: Manually remove molds with Pan pill. There are three methods of using the coating pan to mold and the particle sieving from the mold, but all have the disadvantages of time-consuming and laborious, large particle size difference, or insufficient roundness. Through practice, we have explored a new method of die-cutting, that is, using a coating pan to start the process of pan pellet formation. The method is as follows: When the first pan balls in the pot are molded to the prescribed specifications of the pills, the amount of the disposable medicine powder is properly dispersed and the adhesive is sprayed, and the natural rotation is allowed for 4 to 5 minutes so that the powder cannot be completely adhered. The pellets form small particles on the surface and sink to the bottom of the pot. At this point, stop using your fingers to turn over the balls.