【摘 要】
：
An experimental study was conducted on turbulent separation behaviors induced by blunt fins with different sweep angles at Mach number 6.0.The Nano-particle based Planar Laser Scattering technique (NPLS) was applied to visualize the flowfield,complemented
【机 构】
：
College of Aerospace Science and Engineering,National University of Defense Technology,Changsha 4100
论文部分内容阅读
An experimental study was conducted on turbulent separation behaviors induced by blunt fins with different sweep angles at Mach number 6.0.The Nano-particle based Planar Laser Scattering technique (NPLS) was applied to visualize the flowfield,complemented by pressure tests.Sweep angles of the fins were 10°,20°,60°,with the same leading edge diameter of 10 mm.Fine structures of the interference flowfield induced by blunt fins have been obtained,including the shock systems and vortexes.It was found that the features and shapes of the detached shock depended on sweep angle.When sweep angle ＜ 50°,the detached shock appeared as the form of trailing shock,and the supersonic jet with its reflection could be observed.The detached shock would be curved for the 50° and 60° fins and became a transmitted shock.The Scale-Invariant Feature Transform(SIFT) was successfully applied to obtain the velocity field from NPLS images,and the extent of the separated region was found to decrease with increasing sweep angle.No separation appeared as sweep angle ＞ 30°.Two peak values were detected on the centerline pressure distribution.The first peak did not rely on sweep angle,while the second peak value decreased with increasing sweep angle.
其他文献
Numerical studies were performed to investigate the mechanism and potential of several active rotors for reducing low-frequency in-plane thickness noise generated by rotating blades.A numerical method coupling the blade element theory,prescribed wake mode
The film cooling effectiveness of two turbine blades at different turbulence intensities(0.62％ and 16.00％) and mass flux ratios (2.91％,5.82％,8.73％ and 11.63％) is studied by using the Pressure-Sensitive Paint (PSP) measurement technique.There are a baselin
Computational mesh is an important ingredient that affects the accuracy and efficiency of CFD numerical simulation.In light of the introduced large amount of computational costs for many adaptive mesh methods,moving mesh methods keep the number of nodes a
The precooler is a distinctive component of precooled air-breathing engines but consti-tutes a challenge to conventional thermal design methods.The latter are based upon assumptions that often reveal to be limited for precooler design.In this paper,a refi
The decrease in aerodynamic performance caused by the shock-induced dynamic stall of an advancing blade and the dynamic stall of a retreating blade at low speed and high angles of attack limits the flight speed of a helicopter.However,little research has
This paper presents the results of a numerical study of the effects of swirling flow in cool-ant jets on film cooling performance.Some combined-hole designs with swirling coolant flow enter-ing the delivery hole are proposed and analyzed.Adiabatic film co
Inverse design has long been an efficient and powerful design tool in the aircraft industry.In this paper,a novel inverse design method for supercritical airfoils is proposed based on genera-tive models in deep learning.A Conditional Variational AutoEncod
Characteristics of particle migration and deposition were numerically investigated in presence of aggressive swirl at the turbine inlet.The isolated effects of the inlet swirl were considered in detail by shifting the circumferential position of the swirl
The variable geometry supersonic inlet tends to decrease the throat area to reduce the Mach number upstream of the terminal shock,so as to reduce the flow loss.However,excessive Internal Contraction Ratio (ICR) exposes the inlet to a greater risk of unsta
For the landing legs with single air chamber in the buffer structure of the reusable land-ing vehicle,the geometric topological models and the dynamic model associated with the hard points of the landing legs are established.The geometric constraint relat