论文部分内容阅读
Low-cycle fatigue behavior of permanent mold cast and die-cast AI-Si-Cu-Mg alloys
【机 构】
：
SchoolofMaterialsScienceandEngineering
【出 处】
：
中国铸造：英文版
【发表日期】
：
2012年1期
其他文献
Effect of cooling rate on solidification structure and linear contraction of a duplex stainless stee
Cooling rate is a key factor that can drastically affect the phase transformation and thermal stress of duplex stainless steels. Therefore, in this research, di
期刊
When castings become complicated and the demands for precision of numerical simulation become higher,the numerical data of casting numerical simulation become m
期刊
Bentonite is one of the most widespread used clays connected with various applications. In the case of foundry technology, bentonite is primarily used as a bind
期刊
Zhejiang Hongshun Light Alloy Technology DevelopmentCo., Ltd. applys for the new three board listing
Zhejiang Hongshun Light Alloy Technology Development Co., Ltd.（Hongshun Technology） has recently officially applied for the new threeboard listing. The announceme
Effect of residual AI content on microstructure and mechanical properties of Grade B＋Steel for casti
The bogie made of Grade B+ steel is one of the most important parts of heavy haul trains. Some accidents were found to be the result of fracture failure of the
期刊
Solute redistribution and Rayleigh number in the mushy zone during directional solidification of Inc
The interdendritic segregation along the mushy zone of directionally solidified superalloy Inconel 718has been measured by scanning electron microscope (SEM) an
光显微镜( OM )，与精力扫描电子显微镜( SEM )散分光计(版本)和X光检查衍射计( XRD )被采用分析 La2 ( CO3 )的效果 3 在微观结构和 ZM-5 的机械性质上镁合金，并且在合金的机械
In order to improve the performances of the Al-Mg-Si-Cu-Cr-V alloy,various amounts of Mn(0-0.9wt.%) were added.The effect of this Mn on the microstructures and