论文部分内容阅读
The article introduces a new method for three-dimensional reproduction of edentulous dental casts,and wax occlusion rims with jaw relation by using a commercial high-speed line laser scanner and reverse engineering software and evaluates the method’s accuracy in vitro.The method comprises three main steps:(i)acquisition of the three-dimensional stereolithography data of maxillary and mandibular edentulous dental casts and wax occlusion rims;(ii)acquisition of the three-dimensional stereolithography data of jaw relations;and(iii)registration of these data with the reverse engineering software and completing reconstruction.To evaluate the accuracy of this method,dental casts and wax occlusion rims of 10 edentulous patients were used.The lengths of eight lines between common anatomic landmarks were measured directly on the casts and occlusion rims by using a vernier caliper and on the three-dimensional computerized images by using the software measurement tool.The direct data were considered as the true values.The paired-samples t-test was used for statistical analysis.The mean differences between the direct and the computerized measurements were mostly less than 0.04 mm and were not significant(P.0.05).Statistical significance among 10 patients was assessed using one-way analysis of variance(P,0.05).The result showed that the 10 patients were considered statistically no significant.Therefore,accurate three-dimensional reproduction of the edentulous dental casts,wax occlusion rims,and jaw relations was achieved.The proposed method enables the visualization of occlusion from different views and would help to meet the demand for the computer-aided design of removable complete dentures.
The article introduces a new method for three-dimensional reproduction of edentulous dental casts, and wax occlusion rims with jaw relation by using a commercial high-speed line laser scanner and reverse engineering software and evaluates the method’s accuracy in vitro. (i) acquisition of the three-dimensional stereolithography data of maxillary and mandibular edentulous dental casts and wax occlusion rims; (ii) acquisition of the three-dimensional stereolithography data of jaw relations; and (iii) registration of these data with the reverse engineering software and completing reconstruction. To evaluate the accuracy of this method, dental casts and wax occlusion rims of 10 edentulous patients were used. These lengths of eight lines between common anatomic landmarks were measured directly on the casts and occlusion rims by using a vernier caliper and on the three-dimensional computerized images by using the software measurement tool. The direct data were consi dered as the true values. The paired-samples t-test was used for statistical analysis. The mean differences between the direct and the computerized measurements were mostly less than 0.04 mm and were not significant (P <0.05) .Statistical significance among 10 patients was assessed using one-way analysis of variance (P, 0.05). The result showed that the 10 patients were suggesting statistics no significant. Beforefore, accurate three-dimensional reproduction of the edentulous dental casts, wax occlusion rims, and jaw relations was achieved . The proposed method enables the visualization of occlusion from different views and would help to meet the demand for the computer-aided design of removable complete dentures.