【摘 要】
：
The propagating characteristics of the water and muddy waves are one of the concerns of theoretical studies because of the following facts:(1) With the development of the economy in the estuaries,local residents and government paid increasing attention to
【机 构】
：
State Key Laboratory of Hydraulic Engineering Simulation and Safety,Tianjin University,Tianjin 30007
论文部分内容阅读
The propagating characteristics of the water and muddy waves are one of the concerns of theoretical studies because of the following facts:(1) With the development of the economy in the estuaries,local residents and government paid increasing attention to the ecological environment of the estuarine beaches The propagating characteristics of the water and muddy waves are closely related to the ecological environment,the concern of the government and the residents.(2) The propagating characteristics of the mud are the bottleneck of the study of the coastal and beach dynamics because of the complicated constitutive relation of the mud.The different constitutive models may lead to different explanations of its mechanism.Hence,the proper selection of the model is one of the keys to reveal the true kinematic properties of the mud in the estuaries.This paper first establishes a power law model of the constitutive relation of the mud.Based on this model,a gravity wave theory is proposed.According to the mechanism of the mud wave transportation,the coupled mud-water wave field can be divided into two layers.The upper layer is described as the viscous Newtonian fluid,whereas the lower high-concentration mud layer is described as the power law fluid.Next,the equations of the proposed model are discretized and the calculations are made by using the difference method.Then,the propagating characteristics are discussed,and the dispersion relations of the water and mud waves are analyzed in detail.
其他文献
研究了从铜冶炼黑铜泥中低温加压氧化浸出铜、砷,考察了温度、初始硫酸质量浓度、氧分压、液固体积质量比对铜、砷浸出的影响.结果表明:在初始硫酸质量浓度80 g/L、液固体积质量比10/1、温度120℃、氧分压0.3 M Pa、反应时间60 min条件下,黑铜泥中的铜、砷浸出率分别达99.5％ 和98.5％.浸出渣中锑和铋质量分数较原料(黑铜泥)富集8.5倍和14.9倍.
Rough-surface Rayleigh-Bénard convection is investigated using direct numerical simulations in two-dimensional convection cells with aspect ratio Γ=2.Three types of fractal roughness elements,which are marked as nl,n2 and n3,are constructed based on the K
The load rejection imposes a danger in the pumped storage hydropower plants (PSPs),especially when two or more pump turbines reject their loads simultaneously.In this paper,the simultaneous load rejection scenarios in the PSPs are simulated and analyzed b
The air layer drag reduction (ALDR) of an axisymmetric body in oscillatory motions is investigated in this paper with open source toolbox OpenFOAM.The unsteady Reynolds-averaged Navier-Stokes (URANS) equations are used to determine the viscous flow and th
研究了用硫酸从转底炉粗锌粉中浸出锌,考察了硫酸质量浓度、浸出温度和时间、固液质量体积比、搅拌速度对锌浸出率的影响.结果表明:在硫酸质量浓度230 g/L、浸出温度35℃、固液质量体积比1/4、浸出时间80 min、搅拌速度400 r/min条件下,锌浸出率达95％ 以上,浸出效果较好.
针对低浓度含金溶液,研究了以旋流电积法一步电积金,考察了溶液浓度、电流密度、溶液pH等条件对Au3+电积析出的影响.结果表明:对于2 L碱性电解液,在金质量浓度5 mg/L、电流密度20 A/m2、电积时间2.0 h条件下,电积效果较好,金析出率达94.66％,溶液中Au3+质量浓度可降至0.267 mg/L,耗电量为6.72 kW·h.旋流电积法可用于从低浓度溶液中回收金.
研究了采用盐酸浸出—水解法从分银渣中分步分离锑、铋、铜和银,考察了各因素对有价金属分离效果的影响.结果表明:在盐酸浓度6 mol/L、液固体积质量比6/1、浸出温度80℃、浸出时间2.0 h、搅拌速度350 r/min条件下,锑、铋、铜浸出率分别为91.93％、96.44％ 和98.27％;通过调节富锑、铋、铜浸出液pH分步沉淀锑、铋,在p H=1.0、陈化时间4 h条件下,锑、铋水解沉淀率分别为96.21％ 和0.84％,得到锑质量分数为58.48％ 的锑富集物;控制锑沉淀母液p H=2.5并陈化4 h
This paper presents a numerical study of the Rayleigh-Bénard convection (RBC) in two-dimensional cells with asymmetric (ratchet) roughness distributed on the top and bottom surfaces.We consider two aspect ratios of roughness γ =1,2 and the range of the Ra
研究了采用一种新型萃取剂A从电解锰阳极液中通过溶剂萃取获得制备电池级硫酸锰的高纯溶液,考察了振荡时间、水相pH、萃取剂浓度、有机相皂化率、相比Vo/Va、硫酸铵浓度对萃取的影响,以及相比Vo/Va和酸度对反萃取的影响.结果表明:在Vo/Va=1.5/1、萃取剂体积分数30％、有机相皂化率30％、水相pH=4.6、25℃条件下萃取15 min,锰萃取率为77.9％,镁萃取率为13.7％;用1 mol/L硫酸溶液,在相比V o/V a=6/1条件下反萃取负载有机相,得到平均锰质量浓度53 g/L、酸度较低的反
通过筛选和培育,从某电镀活性污泥中得到一株高效耐Cu2+功能吸附菌,根据菌落形态特征及16S rDNA序列测定和比对,鉴定出该菌株为芽孢杆菌属中的枯草芽孢杆菌(Bacillus subtilis-TR1).研究了用此菌种从电镀废水中吸附去除C u2+,考察了废水初始p H、C u2+初始质量浓度、温度、菌种加入量、培养时间及摇床转速等对C u2+去除率的影响.结果表明:在废水初始p H=5、C u2+初始质量浓度80 m g/L、温度30℃、细菌接种量3 g/L、培养时间48 h条件下,此菌种对Cu2+有