论文部分内容阅读
电工接线时,通常都用克丝钳子事先将电线线头绝缘部分剥离线芯,这种剥离方法有两个缺点:1.剥线质量很难保证,工人操作时,用力不小心,常会使线芯受伤,影响接线质量,甚至会使电线报废;2.剥线效率太低。由于有以上缺点,所以,在50年代时曾有人引进国外的剥线钳子,此种钳子基本可以保证线芯不受损伤,能把切开绝缘部分和剥离线芯的两个动作合在一次手工操作中完成,使质量及劳动强度得到了进一步的改善。但在大量的装配中,都显
Electrical wiring, wire crimping pliers are usually used to pre-insulation part of the wire core stripping, this stripping method has two shortcomings: 1. stripping quality is difficult to ensure that workers operate, careless, often make the core Wound, affecting the quality of wiring, or even scrap the wire; 2. Stripping efficiency is too low. Because of the above shortcomings, so in the 1950s when someone was the introduction of foreign stripping pliers, such pliers can basically guarantee that the core is not damaged, can cut off the insulation part of the core and the two movements together in a manual Operation completed, the quality and labor intensity has been further improved. But in a large number of assembly, all significant