【摘 要】
：
TiO2 is a promising photocatalyst. However, the low photocatalytic efficiency calls for the modification of TiO2. Metal- and nonmetal-doping of TiO2 have been p
【机 构】
：
Division of Surface Engineering of Materials,Graduate School of Chinese Academy of Sciences
论文部分内容阅读
TiO2 is a promising photocatalyst. However, the low photocatalytic efficiency calls for the modification of TiO2. Metal- and nonmetal-doping of TiO2 have been proved to be effective ways to enhance photocatalytic properties. This review provides a deep insight into the understanding of the metal- and nonmetal-doped TiO2 photocatalysts. This article begins with the introduction of the crystal structures of TiO2 and applications of TiO2 materials. We then reviewed the doped-TiO2 system in two categories: (1) metal-doped TiO2photocatalysts system, and (2) nonmetal-doped TiO2 photocatalysts system. Both experimental results and theoretical analyses are elaborated in this section. In the following part, for the advantages of TiO2 thin films over particles, various preparation methods to obtain TiO2 thin films are briefly discussed. Finally, this review ends with a concise conclusion and outlook of new trends in the development of TiO2-based photocatalysts.
其他文献
Galvanic corrosion behavior of Ti-1023 titanium alloy coupled 30CrMnSiA steel was investigated in 3.5% NaCl solution. Particular attention was given to the effe
Three types of composite materials were designed and fabricated by hot pressing powder blends of alumina with 20 vol.pct nickel particles.The composites differ
Particle Image Velocimetry(PIV)has been used to investigate turbulence characteristics in a 0.48 m diamctcr stirred vessel filled to a liquid height(H=1.4T)of 0
The chemical composition of the passivating layer formed on nano SnO2 anodes in 1 M LiClO4+(ethylene carbonate)EC+(dimethyl carbonate)DMC at different charge/di
The compact Cu coating with smooth surface and refined grain was prepared at high current density by mechanical attrition enhanced electroplating(MAEE) process.
Electrospinning technique was used to fabricate PVP/Ce(NO3)3 composite mierofibers. Different morphological CeO2 nanofibers were obtained by calcination of the
The fatigue fracture behavior of four ultrahigh strength steels with different melting processes and therefore different inclusion sizes were studied by using a
The preparation of ultra.fine particles of salbutamol sulphate(SS)was accomplished with a reactive precipitation pathway,in Which salbutamo]and sulphuric acid w
Lattice effect on magnetic and electrical transport properties of Ln2/3Pb1/3MnO3 (Ln=La, Pr, Nd) films prepared by RF magnetron sputtering technique were invest
Chrome-doped titanium oxide films were prepared by reactive magnetron sputtering method. The films deposited on glass slides at room temperature were investigat