论文部分内容阅读
The United States Department of Agriculture (USDA) Annualized Agricultural Non-Point Source Pollution model (AnnAGNPS) is used to help evaluate a watershed response to agricultural management practices to control water quality. However, AnnAGNPS version 3.5 does not contain features to estimate the effect of a riparian buffer (RB) system on water quality. The Riparian Ecosystem Management Model (REMM) is used to simulate the impact of riparian buffer systems on water quality. However, frequently the lack of measured upland loadings that are required by REMM simulation limits the application of REMM. To address this data gap, a study was conducted to integrate AnnAGNPS with REMM for RB system simulation. AnnAGNPS was used to simulate water and sediment loadings from an upland field into a three-zone RB system at the Gibbs Farm located in the Georgia coastal plain. These AnnAGNPS outputs were used as the inputs to REMM. REMM was used to simulate water and sediment movement along the riparian buffers. The AnnAGNPS simulated amount of annual runoff at the edge of the field was close to observed amounts (Nash-Sutcliffe efficiency of 0.92). It is believed that a substantial portion of sand was removed from the runoff one meter into the grass buffer where the samplers were located; therefore, sand was excluded from the AnnAGNPS simulation for comparison with observed sediment. Excluding sand, the AnnAGNPS predicted amount of annual sediment matches the observed amount fairly well (Nash-Sutcliffe efficiency of 0.46). In addition, based on evaluating the percent reduction of sediment at each zonal interface, the AnnAGNPS/REMM model well simulated the function of the RB system to reduce sediment.
The United States Department of Agriculture (USDA) Annualized Agricultural Non-Point Source Pollution model (AnnAGNPS) is used to help evaluate a watershed response to agricultural management practices to control water quality. However, AnnAGNPS version 3.5 does not contain features to estimate the effect of the riparian buffer (RB) system on water quality. The Riparian Ecosystem Management Model (REMM) is used to simulate the impact of riparian buffer systems on water quality. However, frequently the lack of measured upland loadings that are required by REMM simulation limits the application of REMM. To address this data gap, a study was conducted to integrate AnnAGNPS with REMM for RB system simulation. AnnAGNPS was used to simulate water and sediment loadings from an upland field into a three-zone RB system at the Gibbs Farm located in the Georgia coastal plain. These AnnAGNPS outputs were used as the inputs to REMM. REMM was used to simulate water and sediment movement along the ripa rian buffers. The AnnAGNPS simulated amount of annual runoff at the edge of the field was close to observed amount (Nash-Sutcliffe efficiency of 0.92). It is believed that a substantial portion of sand was removed from the runoff one meter into the grass buffer where the samplers were located; therefore, sand was excluded from the AnnAGNPS simulation for comparison with observed sediment. Excluding sand, the AnnAGNPS predicted amount of annual sediment matches the observed amount fairly well (Nash-Sutcliffe efficiency of 0.46). on evaluating the percent reduction of sediment at each zonal interface, the AnnAGNPS / REMM model well simulated the function of the RB system to reduce sediment.