论文部分内容阅读
根据国家计量法和院程序文件Q/ZYY·ZC1101《检验、测量和试验设备的控制》的要求,对反应堆工程研究设计所10个研究室进行计量器具的系统管理工作。重新整理了计量器贝台帐,将现有的和新购置的计量器具登记上帐,确认经过检定或校准合格后方可使用。当计量器具的状态发生变化时,及时对台帐进行动态管理。根据台帐上的检定（校准）日期和周期,监督实际送检情况,杜绝计量器具的超周期使用。对于国家无检定规程的计最器具,依据经过批准的、自编的校准方法开展校准工作,并做好校准记录。采用《合格》、《禁用》或《限用》的彩色标志,对计量器具的状态进行了标志管理,使现场计最器具的状态一目了然,保
According to the requirements of the National Metrology Law and the Procedural Document Q / ZYY · ZC1101 “Control of Inspection, Measurement and Test Equipment”, systematic management of the measuring instruments was carried out on 10 research institutes of Reactor Engineering Research and Design Institute. Rearrange the meter Beitai account, the existing and newly acquired measuring instruments registered on the account, confirmed after passing the test or calibration before use. When the status of measuring instruments changes, timely dynamic management of Taiwan accounts. According to the verification (calibration) date and period on the ledger, supervise the actual inspection and put an end to the super-cycle use of measuring instruments. For the national standard test instruments, according to the approved, self-calibration method to carry out calibration work, and make calibration records. The use of “qualified”, “disabled” or “limited” color signs, the status of the measuring instruments were flag management, so that the scene most of the state equipment at a glance Paul