【摘 要】
：
Nucleation and growth model based on Cellular Automation(CA) incorporated with macro heat transfer calculation was presented to simulate the microstructure of a
【机 构】
：
College of Mechanical and Electronic Engineering,Department of Mechanical Engineering
论文部分内容阅读
Nucleation and growth model based on Cellular Automation(CA) incorporated with macro heat transfer calculation was presented to simulate the microstructure of aluminum twin-roll casting. The dynamics model of dendrite tip (KGT model) was amended in view of characteristics of aluminum twin-roll casting. Through the numerical simulation on solidification structure under different casting speeds, it can be seen that when the casting speed is 1.3 m/min, that is, under conditions of conventional roll casting, coarse columnar grains dominate the solidification structure, and equiaxed grains exist in the center of aluminum strip. When the casting speed continuously increases to 8 m/min, that is, under the conditions of thin-gauge high-speed casting, columnar grains in solidification structure all convert into equiaxed grains. Experimental and numerical results agree well.
其他文献
The dynamic recrystallization(DRX)behavior of Nb-Ti microalloyed steels was investigated by isothermal single compression tests in the temperature range of 900-
Steel matrix composite coatings locally reinforced with in situ TiC-TiB2 particulates were prepared by argon arc cladding(AAC) with different mass fractions of
BaCe0.45Zr0.45M0.1O3-δ (M=Y, In) and BaCe0.9Y0.1O3-δ were prepared through the conventional solid state reaction route. The chemical stability was investigate
Ordered Ni70Fe30 nanowire array was fabricated in a porous alumina template by altemating current electrodeDositiOn.The structural and magnetic properties of th
We propose the spectrum allocation and resource scheduling algorithms in cognitive point to multipoint (PMP)networks with rapid changes of spectrum opportunitie
The structure and electrical properties of(Na0.5Bi0.5)0.94Ba0.06TiO3 ceramic doped with 0.5 wt% of MnO were investigated in comparison with those of(Na0.5Bi0.5)
Reduction of Bama ilmenite concentrate containing 49.78% TiO2 and 27.96% total Fe by graphite was studied using thermogravimetric analysis system under argon ga
Asymmetric rolling(ASR), as one of severe plastic deformation(SPD) methods, was widely used to make ultra-fined materials with enhanced performance. Internal ma
In this review, the progress made during the last two years with respect to the syntheses and novel properties of one-dimensional (1D) ZnS nanostructures is pre